Digilent Cmod S6 참조 매뉴얼

{카테고리_이름} Digilent Cmod S6에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilent Cmod S6 5 페이지. Fpga board

페이지 인쇄

Cmod S6™ FPGA Board Reference Manual

Revised January 30, 2014

This manual applies to the Cmod S6 rev. A

Overview

The Digilent Cmod S6 is a small, 48-pin DIP form factor board built around a Xilinx Spartan 6 LX4 FPGA. The board

also includes a programming ROM, clock source, USB programming and data transfer circuit, power supplies, and

basic I/O devices. There are 46 FPGA I/O signals that are routed to 100-mil-spaced through-hole pins, making the

Cmod S6 well suited for use with solderless breadboards. At just .7" by 2.6" inches, it can also be loaded in a

standard socket and used in embedded systems.

The Cmod S6.

Configuration

The FPGA on the Cmod S6 can be configured using the on-board Adept USB interface or from the on-board Quad-

SPI Flash memory. Configuration files can be programmed using Xilinx's ISE 14.2 (or higher) development tools,

using Digilent's Adept system, or using older versions of the Xilinx tools if Adept is also installed. Xilinx's ISE/Impact

programming tool and Digilent's Adept tool will recognize the board and/or FPGA when the board is attached to a

PC using a Type-A to micro-B USB cable.

Xilinx's iMPACT tool and Digilent's Adept can both be used to program the FPGA, and iMPACT can also be used to

program the on-board QSPI Flash. Please refer to the ISE and/or Adept documentation for more information on

using the configuration software.

DOC#: 502-282

Other product and company names mentioned may be trademarks of their respective owners.

Spartan 6 XC6SLX4-2CPG196 FPGA features include:



600 slices (each with 4 LUTs and eight flip-flops);



8 DSP slices;



216Kbits of block RAM;



2 CMTs (4 DCMs and 2 PLLs).

Cmod S6 features include:



16Mbyte Spansion Quad SPI Flash for storing FPGA

configurations and/or user data;



46 FPGA GPIO signals brought to DIP pins;



Two on-board clock sources;



4 user LEDs and 2 user buttons;



On-board Adept USB2 port for configuration, test and

communications interfaces.

1300 Henley Court

Pullman, WA 99163

509.334.6306

www.digilentinc.com

Page 1 of 4