Archos DVR Station 연결 매뉴얼 - 페이지 2

{카테고리_이름} Archos DVR Station에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Archos DVR Station 4 페이지. Archos dvr station: connection guide
Archos DVR Station에 대해서도 마찬가지입니다: 연결 매뉴얼 (2 페이지), 연결 매뉴얼 (2 페이지), 연결 매뉴얼 (2 페이지)

페이지 인쇄

DVR Station Connection with cable box and television having two scarts each

Antenna

Cable

Satellite

RF input (antenna)

RF output (to TV)

Standard Set up with External Tuner

This setup schematic uses the standard cables supplied with the European version

of the DVR Station.

Watching Regular TV

To just watch television, (whether your ARCHOS is plugged into the DVR Station

or not), you will select input AV1 on your television (the scart you have connected

your tuner to) and you will change the station you are viewing by using your Tuner's

(Cablebox, Satellite Dish, ect.) remote control. There should be no difference from

how you watched TV before and after you installed the DVR Station.

Playing your ARCHOS to the TV

If you want your ARCHOS to play out to your TV, press the TV button of your

ARCHOS remote control. Normally, the TV will be notified by the DVR Station that

it is sending a video signal to the TV and the TV will switch from the AV1 input

(your tuner) to the correct input AV2 (your ARCHOS) and display your ARCHOS

on the TV. If it does not switch automatically to your ARCHOS, then you must

command your television to display from the input that the DVR Station is connected

to. Usually there is a button on the TV's remote control labeled input that will allow

you to change which input is being shown on the television. (in this example, you

would switch to input AV 2). If you do not see the image of the ARCHOS on the

TV when you press the ARCHOS remote control's TV button (the ARCHOS screen

will go to black at this time), check that your video output settings are correct for

your region. (Your ARCHOS must be inserted into the DVR Station for the TV out

settings to be available.)

Tools > Settings > TV out > TV Connection : RGB

Tools > Settings > TV out > TV Standard : PAL (EUROPE)

Recording TV on the ARCHOS

To record TV manually, use your tuner's remote control to choose the station to

record. On the ARCHOS, Choose the bottom icon DVR Station and then select

Video Recorder. You will see the image of your television on the screen with the

ARCHOS on-screen information (volume, record gain, file name, etc.). On the

ARCHOS remote control, press the Menu button (top right button) and select Start

Recording. When you are finished recording, use the menu button again and

select Stop Recording. You can also set the ARCHOS to stop recording after a

specified amount of time by choosing Menu > Settings > Auto Stop Rec. Once

this is set to a given number of hours and minutes, the recording will stop after

that time.

Tuner

(Cable box, DTV receiver, set-top box, Satellite receiver)

TV Scart

VCR Scart

Input Cable

Output Cable

ARCHOS

DVR Station

Television

General Connection Illustration

Tuner

Xtech Cable