Cres Cor AQUATEMP RO151FW1332B-Q1 설치, 운영 및 유지보수 매뉴얼 - 페이지 5
{카테고리_이름} Cres Cor AQUATEMP RO151FW1332B-Q1에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor AQUATEMP RO151FW1332B-Q1 14 페이지. Humidity convection and retherm ovens with microprocessor controls
페이지 인쇄
5925 Heisley Road • Mentor, OH 44060-1833
HOW TO SET THE CONTROL, continued
FOR PROBE COOK OPERATION:
Press the SELECT button to choose the probe mode.
PROBE TEMPERATURE:
1.
Press the PROBE/TIME button. The display will show
the probe setpoint temperature.
2.
Use the UP and DOWN arrows to set the desired
temperature.
3.
Press the SET button to enter the temperature into the
control.
NOTE: Press the OVEN TEMP button at any time to
view the actual oven temperature. Press the
START button and the display will show the
actual probe temperature.
NOTE: The control will beep when the probe setpoint
temperature has been reached and then will
automatically switch to HOLD mode. The
display will then show the hold setpoint
temperature.
To manually end the COOK/RETHERM, PROBE,
or HOLD mode:
Press the STOP button during any of the above modes and
the control will end that mode. If in the Cook/Retherm or
Probe mode, the control will automatically switch into the
HOLD mode.
HOW TO OPERATE WITH FOOD:
Manual (Timed mode) Operation
See "HOW TO SET THE CONTROL" (on page 4) for
programming instructions.
1.
Push power switch to "ON".
2.
Press the SELECT button and choose the TIMED
mode.
3.
Press the COOK button and set to desired temperature.
4.
Press the PROBE/TIME button and set to the desired
time.
5.
Press the HOLD button; set desired temperature.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
OPERATING INSTRUCTIONS, continued
Ovens Humidity with
Microprocessor Controls
Rev. 14 (6/08)
6.
Place the food into oven. Close door and double
check cooking time and temperatures. Then press the
START button to start the cooking/retherm cycle and
the Cook LED will light up.
7.
The oven will beep and automatically switch to the
HOLD mode at the end of the cooking cycle. The
Cook lamp will go out and the Hold lamp will light
up.
Probe Cooking
See "HOW TO SET THE CONTROL" (on page 5) for
programming instructions.
1.
Push power switch to "ON".
2.
Press the SELECT button and choose the Probe mode.
3.
Insert the probe jack into the receptacle located inside
the oven top, near the fans. The probe temperature
display will show the digital temperature of the probe.
4.
Put sanitized probe into center of food product. Make
sure food is in the center of the pan and the pan is
centered in the oven.
5.
Press the start button. The cook lamp will light up and
the display will show the internal temperature of the
food being cooked.
NOTE: Do NOT change the mode of the controls (probe
or timed) while oven is operating in a Cook/
Retherm cycle. Oven must be in the HOLD cycle
to change the timer or probe operation.
FL-2267
Page 5 of 14