Cres Cor H-339225 Series 운영 및 유지보수 지침

{카테고리_이름} Cres Cor H-339225 Series에 대한 운영 및 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor H-339225 Series 4 페이지. Insulated hand-lift cabinets

페이지 인쇄

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

ELECTRICAL SPECIFICATIONS:

MODELS:

H-339225-01 / HOT CABINET TOP

H-339225-02 / PROOFER BOTTOM

H-339SS1814CBE / HOT CABINET ONLY

HOW TO INSTALL UNIT: (Figure 1)

See FL-2211-BE (enclosed) for "Stacking

Instructions".

1. Plug cord into receptacle in back of the unit.

2. Turn plug clockwise to lock.

3. Plug other end into 15-amp wall outlet.

4. Place cabinet in a well ventilated area.

5. If no casters are provided, the base must be sealed

to the counter or floor with grout or caulk to

maintain sanitation certification.

6. Push the switch on, turn the thermostat to No. 10

and run the unit for one hour.

NOTE: DO NOT PUT IN FOOD! This step is to

burn off manufacturing oils and excessive

adhesive.

6. Let the cabinet cool and wipe inside clean with

detergent and hot water before use.

HOW TO OPERATE UNIT: (Figure 2)

1. Push switch "ON". Yellow light will come on.

2. Preheat cabinet for 45 minutes; the cabinet

temperature is factory preset.

4. Put food into cabinet.

To Turn Off Unit:

Push switch "OFF". The yellow light will go off.

NOTE: The digital thermometer will flash if cabinet

temperature is below 140°F/60°C or above

250°F/60°C.

Call the factory if you need different settings.

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

For INSULATED HAND-LIFT CABINETS

MODEL H-339225 and H339SS1814CBE

Volts

Watts

Amps

120

900

120

900

120

900

FIG. 2

Insulated

Hand-lift Cabinets

Rev. 8 (5/13)

Hertz

Phase

7.5

THERMOSTAT

THERMOMETER

COVER

SWITCH

FL-0520-BE

Page 1 of 4

NEMA

5-15

FIG. 1