Digilent Atlys 참조 매뉴얼 - 페이지 6
{카테고리_이름} Digilent Atlys에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilent Atlys 19 페이지. Circuit board
페이지 인쇄Atlys Reference Manual
File I/O
The File I/O tab can transfer arbitrarily large
files between the PC and the Atlys FPGA. A
number of bytes (specified by the length value)
can be streamed into a specified register
address from a file or out of a specified register
address into a file. During upload and
download, the file start location can be
specified in terms of bytes.
As with the Register I/O tab, File I/O also
requires specific IP to be available in the
FPGA. This IP can include a memory
controller for writing files into the on-board
DDR2 and Flash memories.
A reference design demonstrating the required
IP is available on the Digilent website.
I/O Expand
The I/O Expand tab works with an IP block in
the FPGA to provide additional simple I/O
beyond the physical devices found on the Atlys
board. Virtual I/O devices include a 24-LED
light bar, 16 slide switches, 16 push buttons, 8
discrete LEDs, a 32-bit register that can be
sent to the FPGA, and a 32-bit register that can
be read from the FPGA. The IP block, available
in a reference design on the Digilent website,
provides a simple interface with well-defined
signals. This IP block can easily be included in
and accessed from user-defined circuits.
For more information, please see the Adept
documentation available at the Digilent
website.
Doc: 502-178
page 6 of 19