Digilent chipKIT Network Shield 참조 매뉴얼 및 사용자 가이드 - 페이지 3
{카테고리_이름} Digilent chipKIT Network Shield에 대한 참조 매뉴얼 및 사용자 가이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilent chipKIT Network Shield 11 페이지. Chipkit network shield board
Digilent chipKIT Network Shield에 대해서도 마찬가지입니다: 참조 매뉴얼 (11 페이지)
페이지 인쇄chipKIT Network Shield Reference Manual
6) CAN2 Connector
This connector provides access to the signals for CAN2.
7) CAN1 Connector
This connector provides access to the signals for CAN1.
8) Digital Signal Connector
This connector provides most of the signals used by the Ethernet and USB interfaces from
the Max32 board to the Network Shield board. The remaining signals are passed through
the Network Shield.
9) J7 – I
2
C #1 Daisy Chain Connector
This is a 2x4 pin header connector that provides access to the I
as well as power from the 3.3V power bus and ground. This can be used to extend the I
bus off of the board and to power external I
2
of I
C peripheral modules that can be accessed using this connector.
10) J7 – I
2
C #2 Daisy Chain Connector
This is a 2x4 pin header connector that provides access to the I
as well as power from the 3.3V power bus and ground. This can be used to extend the I
bus off of the board and to power external I
board pull-ups are adjacent to this connector.
11) Digital Signal Connectors
Some of the signals used by the Network Shield are provided on these connectors. The
rest of the signals are passed through the Network Shield.
www.digilentinc.com
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
2
C signals SDA and SCL
2
C device. Digilent has cables and a selection
2
C signals SDA and SCL
2
C device. The jumpers for disabling the on-
2
C
2
C
page 3 of 11