Cres Cor H138NPSCDOM3MQCE 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Cres Cor H138NPSCDOM3MQCE에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor H138NPSCDOM3MQCE 12 페이지. Hot cabinet

5925 Heisley Road • Mentor, OH 44060-1833

WARNING

IF UNIT GETS TOO HOT OR WON'T SHUT OFF, DISCONNECT

POWER AT BRANCH PANEL. DO NOT UNPLUG CORD!

SIMPLE TROUBLE-SHOOTING CHART:

FAILURE

1. POWER LIGHT does NOT light

2. Unit does not heat or not heating properly 2a. Temperature control is set too low.

3. Unit gets too hot or won't shut off.

4. Blower does not work or makes noise

5. GFCI device trips

If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly

qualified persons in order to avoid a hazard.

If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400

MAINTENANCE INSTRUCTIONS

TROUBLE-SHOOTING GUIDE

POSSIBLE CAUSE

1a. Switch is "OFF"

1b. Cord is unplugged from wall outlet.

1c. Circuit breaker/fuse to wall outlet tripped/blown.

2b. Switch is "OFF".

2c. Doors are open too much.

2d. Gaskets are worn or torn.

2e. Thermometer not reading true temperature. Check cabinet

temperature with another thermometer.

3a. Defective thermostat or blower.

4a. Defective blower.

5a. Plug the cabinet into a non-GFCI outlet and set the

temperature control to its maximum. Let the cabinet run

for about 1 hour to dry out the heating element from any

moisture that may have been absorbed. After drying the

heating element, plug cabinet into the GFCI receptacle; the

cabinet should run properly. If the GFCI device continues

to trip, call the factory Authorized service agent.

FL-2344-DOM

Holding Cabinet

Rev. 4 (4/10)

Page 7 of 12