Digilent chipKIT Uno32 참조 매뉴얼 - 페이지 4

{카테고리_이름} Digilent chipKIT Uno32에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilent chipKIT Uno32 18 페이지.

chipKIT Uno32 Reference Manual

13. User LEDs

Two LEDs connected to digital signal pins 13 and 43.

14. J6 – Digital Signal Connector

This connector provides access to digital I/O pins on the microcontroller.

15. JP4 – Pin 10 Signal Select Jumper

This jumper is used to switch connector J5 pin 5 (digital signal 10) between pulse width

modulator (PWM) operation and SPI operation. The jumper is placed in the RD4 position

for PWM output and in the RG9 position for SPI slave operation. The shorting block on this

jumper will normally be in the RD4 position. The only time it normally needs to be in the

RG9 is when using the Uno32 board as an SPI slave device.

16. J5 – Digital Signal Connector

This connector provides access to digital I/O pins on the microcontroller.

17. Communications Status LEDs

These LEDs indicate activity on the USB serial interface.

18. Reset Button

This button can be used to reset the microcontroller, restarting operation from the boot

loader.

www.digilentinc.com

page 4 of 17