Cres Cor AQUATEMP CO151FPWUA12B-Q1 설치, 운영 및 유지보수 매뉴얼 - 페이지 7
{카테고리_이름} Cres Cor AQUATEMP CO151FPWUA12B-Q1에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor AQUATEMP CO151FPWUA12B-Q1 14 페이지. Humidity convection and retherm ovens with microprocessor controls
Cres Cor AQUATEMP CO151FPWUA12B-Q1에 대해서도 마찬가지입니다: 사양 (2 페이지)
페이지 인쇄
5925 Heisley Road • Mentor, OH 44060-1833
MAINTENANCE: WATER PAN
Drain, wipe and fi ll water pan daily.
(Clear vinyl drain-hose is provided).
1.
Push hose onto drain nozzle under the base.
2.
Turn knob to open the drain.
To Fully Dry Out:
1.
Drain until 1/8" of water is left in pan bottom.
2.
Turn humidity Thermostat to "High" until water is
gone.
3.
Wipe out pan.
CAUTION
Delime or descale water pan parts as required,
to prevent damaging build-up.
WARRANTY COVERAGE MAY BE AFFECTED
WITHOUT PROPER CLEANING.
Cleaning Hints:
1.
Use the mildest cleaning procedure that will do the
job.
2.
Always rub in the direction of the polish lines to avoid
scratching the surface.
HOW TO CLEAN THE UNIT:
SOIL
ROUTINE CLEANING
CABINET
STUBBORN SPOTS,
STAINS
Inside and Outside
BURNT ON FOODS OR
GREASE
(Stainless Steel)
HARD WATER SPOTS &
SCALE
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
MAINTENANCE INSTRUCTIONS
HOW TO CLEAN THE UNIT
* Mild detergents include soaps and non-abrasive cleaners
MAINTENANCE: CABINET
1. Wipe the inside of cabinet after daily use.
2. Leave doors slightly open to fully dry interior.
WARNING
BEFORE
cleaning the cabinet:
1.
Unplug cord from wall. Allow cabinet to
cool.
2.
Do NOT hose cabinet with water.
3.
Do NOT get water on controls.
4.
Do NOT use abrasives or harsh
chemicals.
3.
Use only a soft cloth, sponge, fi brous brushes, plastic
or stainless steel pad for cleaning and scouring.
4.
Rinse thoroughly with fresh water after every cleaning
operation.
5.
Always wipe dry to avoid water marks.
CLEANER
Soap, ammonia or mild
detergent* and water.
Mild abrasive made for
Stainless Steel.
Chemical oven cleaner
made for Stainless Steel.
Vinegar
Ovens Humidity with
Microprocessor Controls
Rev. 14 (6/08)
METHOD
1. Sponge on with cloth
2. Rinse
1. Apply with damp sponge or cloth.
2. Rub lightly.
Follow oven cleaner manufacturer's
directions.
1. Swab or wipe with cloth.
2. Rinse and dry.
FL-2267
Page 7 of 14