Cres Cor CO-151-HW-UA-6B 사양 - 페이지 2
{카테고리_이름} Cres Cor CO-151-HW-UA-6B에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor CO-151-HW-UA-6B 2 페이지. Cres cor aquatemp humidity convection and retherm ovens
Cres Cor CO-151-HW-UA-6B에 대해서도 마찬가지입니다: 설치, 운영 및 유지보수 매뉴얼 (13 페이지), 설치, 운영 및 유지보수 매뉴얼 (13 페이지)
페이지 인쇄DETAIL OF
PAN SLIDE
CRES COR
PAN
MODEL NO.
CAP/ANGLES
6
CO-151-HW-UA-6B
SETS
NOTE: Refer to pan size chart at end of section.
ALL CONSTRUCTION IS RIVETED, WELDED AND FINISHED.
CABINET:
• Body: 22 ga. 304 stainless steel.
• Reinforcement: Internal framework of 16 ga. stainless steel.
• Insulation: Fiberglass, thermal conductivity (K factor) is .23
•
at 75˚F. 1-1/2" in back wall, door, base; 2" in side walls.
• Water pan: 4 Gallons; 16 ga. 304 stainless steel with 1850 Watt
•
heater and with petcock drain; mounted to base.
• Drip trough: Formed 18 ga. stainless steel; mounted to lower
front of cabinet.
• Air tunnel: 20 ga. stainless steel, lift-out type, mounted
•
on rear wall.
• Work top: 18 ga., 304 stainless steel.
BASE:
• One piece construction, .125 aluminum.
• Casters: 5" dia., swivel, modulus tires, 1-1/4 wide, load cap.
•
250 lbs. each, temp. range -45˚/+180˚F. Delrin bearings. Front
casters equipped with brakes.
DOOR:
• Field reversible.
• Formed 22 ga. 304 stainless steel.
• Latch: Chrome plated zinc with composite handle, ceramic
•
magnetic type; mounted inboard.
• Hinges: Heavy duty chrome plated zinc, mounted inboard.
• Gasket: Perimeter type, silicone.
• Pan stop: Embossed.
PAN SLIDES:
• Stainless steel wire universal angles (.306 dia.) mounted on
•
lift-out posts.
• 6 sets of angles adjustable on 1-1/2" centers.
• Grids (3): Nickel chrome plated steel, raised wire 17" x 25".
POWER REQUIREMENTS AVAILABLE:
• 4950 Watts, 208 Volts, 60 Hz., 1 phase, 24 Amps.,
•
30 Amp. service.
• 4950 Watts, 240 Volts, 60 Hz., 1 phase, 21 Amps.,
•
30 Amp. service.
• 4950 Watts, 208 Volts, 60 Hz., 3 phase, 15 Amps.,
•
20 Amp. service.
• 4950 Watts, 240 Volts, 60 Hz., 3 phase, 13 Amps.,
•
20 Amp. service.
5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: 440/350-7267
www.crescor.com
© Crescent Metal Products, Inc. 1998 All rights reserved.
DIM "A"
SIZE
WIDTH
SEE NOTE IN
28-3/4
BELOW
MM
740
®
DIM "B"
DIM "C"
DEPTH
HEIGHT
WIDTH
37-3/4
43-3/4
21-1/4
960
1115
540
POWER UNIT COMPONENTS: (refer to above drawing)
• Body: Formed 304 stainless steel with black control panel, recessed
and tilted 7˚.
• Power cord: Permanent, 6 ft., 10/3 ga. with right angle plug.
• Air heaters (3): 2670 Watts each.
• Water heater: 1850 Watts.
• Blower motors (3).
• Vent fans (2).
• Fuses (2): 3 amp.
A) Thermostat (holding): Solid state, room ambient to 250˚F. (121˚C.).
B) Thermostat (cook/retherm): Solid state, room ambient to
350˚F. (176.5˚C.).
C) Thermostat (humidity): Solid state
D) Switch: Lighted ON-OFF rocker type.
E) Timer: 24 hr. digital countdown; infinite memory retention.
F) Pilot light for low water level.
G) Thermometer.
INSTALLATION REQUIREMENTS:
• Check local vent hood codes for mobile Roast-N-Hold ovens.
SHORT FORM SPECIFICATIONS
Cres Cor AquaTemp Roast-N-Hold Convection Oven Model
CO-151-HW-UA-6B. Removable power unit 20 ga. 304
stainless steel, recessed control panel. Cabinet 22 ga. 304
stainless steel. Stainless steel internal frame; coved corner
interior. 16 ga. stainless steel water reservoir, 4 gallon
capacity. Fiberglass insulation in sides 2"; back, door and
base 1-1/2". 22 ga. 304 stainless steel door, ceramic
magnetic latch, heavy duty hinges. (6) sets universal angles
for multiple pan sizes and spacing. One piece base .125
aluminum. 5" swivel modulus casters, Delrin bearings. Load
capacity 250 lbs. each. 4950 Watts,
____ Phase. 2 year parts warranty. Provide the following
accessories:
Sanitation listed.
In line with its policy to continually improve its products,
CRES COR reserves the right to change materials and
specifications without notice.
CO-151-HW-UA-6B
INSIDE DIMENSIONS
DEPTH
HEIGHT
26-1/2
28
675
715
Volts, 60 Hz.,
___ ___ ___ UL, CUL, UL
WEIGHT
ACT.
LBS
321
KG
146
Litho in U.S.A.