Digilent chipKIT Network Shield 참조 매뉴얼 및 사용자 가이드 - 페이지 2

{카테고리_이름} Digilent chipKIT Network Shield에 대한 참조 매뉴얼 및 사용자 가이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilent chipKIT Network Shield 11 페이지. Chipkit network shield board
Digilent chipKIT Network Shield에 대해서도 마찬가지입니다: 참조 매뉴얼 (11 페이지)

페이지 인쇄

chipKIT Network Shield Reference Manual

chipKIT Network Shield Hardware Overview

The Network Shield has the following hardware features:

1) USB Connectors

The connector on the top of the board is a standard USB A type receptacle. This is used

when the Max32/Network shield is used as a USB host. Immediately below this connector

is a USB Micro-AB connector. Tis connector is used when the Max32/Network Shield is

used as a USB device, or when using it as an On-The-Go (OTG) device.

2) Ethernet Connector with Integral Magnetics

This connector is used to connect the Max32/Network Shield to an Ethernet network..

3) JP4 – USB Host Connector Selection

When the Max32/Network Shield is used as a USB host, this jumper is used to select

which USB connector is being used.

4) J17 – Power Pass-through Connector

This connector passes the power connector from the Max32 through the Network Shield

board, and powers the Network Shield from the Max32.

5) J9 & J12 – Analog Signal Pass-Through Connectors

These connectors pass the analog input pins on the Max32 through the Network Shield

board.

www.digilentinc.com

page 2 of 11