Cres Cor CO151FPUA12B-Q1 설치, 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} Cres Cor CO151FPUA12B-Q1에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor CO151FPUA12B-Q1 13 페이지. Convection and retherm ovens with microprocessor controls
Cres Cor CO151FPUA12B-Q1에 대해서도 마찬가지입니다: 설치, 운영 및 유지보수 매뉴얼 (13 페이지)

페이지 인쇄

Ovens with

Microprocessor controls

Rev. 8 (10/06)

BEFORE CLEANING CABINET:

1. Unplug cord from wall. Allow cabinet to

cool.

2. Do NOT hose cabinet with water.

3. Do NOT get water on controls.

4. Do NOT use abrasives or harsh chemicals.

Wipe up spills as soon as possible.

Clean regularly to avoid heavy dirt build-up.

HOW TO CLEAN THE UNIT:

SOIL

ROUTINE CLEANING

CABINET

STUBBORN SPOTS,

STAINS

Inside and Outside

BURNT ON FOODS OR

GREASE

(Stainless Steel)

HARD WATER SPOTS &

SCALE

IF UNIT GETS TOO HOT OR WON'T SHUT OFF, DISCONNECT

POWER AT BRANCH PANEL. DO NOT UNPLUG CORD!

1. Cord is unplugged from wall outlet.

2. Circuit breaker/fuse to wall outlet is blown.

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

FL-2269

Page 6 of 13

OPERATING INSTRUCTIONS (continued)

* Mild detergents include soaps and non-abrasive cleaners

MAINTENANCE INSTRUCTIONS

TROUBLE-SHOOTING GUIDE

If hot unit is NOT working, ﬁ rst check the following causes:

5925 Heisley Road • Mentor, OH 44060-1833

Hints:

Use the mildest cleaning procedure that will do the job.

Always rub in the direction of the polish lines to avoid

scratching the surface.

Use only a soft cloth, sponge, ﬁ brous brushes, plastic

or stainless steel pad for cleaning and scouring.

Rinse thoroughly with fresh water after every cleaning

operation.

Always wipe dry to avoid water marks.

CLEANER

Soap, ammonia or mild

detergent* and water.

Mild abrasive made for

Stainless Steel.

Chemical oven cleaner

made for Stainless Steel.

Vinegar

3. Switch is turned off.

4. Thermostat is turned off, or is set too low.

METHOD

1. Sponge on with cloth

2. Rinse

1. Apply with damp sponge or cloth.

2. Rub lightly.

Follow oven cleaner manufacturer's

directions.

1. Swab or wipe with cloth.

2. Rinse and dry.