Digilin EDG020 설치 매뉴얼 - 페이지 2
{카테고리_이름} Digilin EDG020에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilin EDG020 2 페이지. Led lighting profile
페이지 인쇄Edge 20 - LED Lighting Profile
Installation Guide
Installation
1.
Connect power and feed cables as required.
4.
Replace the end cap where applicable.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
digilin.com.au
+617 3899 1267
2.
Secure the lower extrusion (mounting tray)
into position using appropriate fasteners
(head height of no more than 3.5mm). Take
care no to place a screw directly below the
cable entry point.
5.
Turn on Power
3.
Press the main extrusion into the mounting
tray.
www.digilin.com.au
Page 2 of 2