Digilin Micro 사용자 설명서 - 페이지 5
{카테고리_이름} Digilin Micro에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilin Micro 5 페이지. Fibre optic lightsource
페이지 인쇄Micro - Fibre Optic Lightsource
User Manual
1.0 - 6 August 2021
Wiring
Unit is supplied with a 12VDc plug
pack.
1.
Connect jack into the socket
on the back of the
lightsource.
2.
Plug the plug pack into
electrical supply. Power
indicator should now
illuminate.
Operation
Unit begins operating once power is properly connected.
Dimming
Light level can be dimmed by pressing the Dimming control button on the rear of the lightsource. Each
press will take the light level a step brighter. Pressing the button again once at full brightness will cycle the
level back down to minimum.
Scintillation Wheel Speed
Rotation speed of the Scintillation wheel can be controlled using Wheel Speed button on the rear of the
lightsource. Each press will make a small increase in rotation speed. Pressing the button again once at
maximum speed will the cycle the speed to off.
Appendix A - Troubleshooting
Unit is dead - LED power indicator is
not illuminated
Unit is dead - no light output but
LED power indicator is still
illuminated
Unit is not twinkling
Poor light output on fibre
digilin.com.au
+617 3899 1267
P r o b l e m
Motor speed push button at stop
Dimming push button at minimum
Fibre port common end not plugged
DC Power Socket
Power Indicator
P r o b a b l e C a u s e
Mains supply off
Loose mains plugs
PSU failed
LED array failure
Twinkle wheel motor failure
in correctly
Unit needs cleaning
Wheel Speed
Dimming Control
R e m e d y
Check supply and re-instate
Check plugs
Replace PSU
Replace Led unit
Press button to start motor
Replace unit
Press button to increase brightness
Ensure plugged in correctly and
secured with locking screw
Carefully clean fibre common end
Page 5 of 5