Accurist W3300 Series 운영 매뉴얼 - 페이지 6

{카테고리_이름} Accurist W3300 Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Accurist W3300 Series 16 페이지.

If desired to use the draft shield ring (included with models W3300-120, W3300-

300, W3300-500), place it carefully over the Weighing Pan. The bottom edge of the

shield will fit on the outside of the 3 raised locating ridges.

Attach the included AC/DC Power Supply adapter to a suitable electrical outlet, and

attached the DC plug end to the balance.

The front display should turn on, and the balance will run through a start up

procedure.

Upon completion of the start-up procedure, the display will light up and the display

will show 0.00.

It is recommended to wait 30 minutes to allow the balance to equilibrate to

the room's temperature before use.

Note that the back light on the display will remain on when the balance is in

10.

use. If the balance is not in use, and there is not a sample on the weigh pan,

the back light will turn off as an energy-saving feature. The W3300 balances

do not have an on/off switch. The power cord can be detached if desired to

turn off the power.

3. OPERATING YOUR BALANCE

It is always recommended to plug in and pre-warm your balance at least 30

minutes before use.

Leveling Bubble