Digilin Slot 25 설치 매뉴얼

{카테고리_이름} Digilin Slot 25에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilin Slot 25 2 페이지. Led lighting profile

페이지 인쇄

Slot 25 – LED Lighting Profile

Installation Guide

Notes

Install in a dry sheltered position

•

Profile is not sealed. Do not install where water or high humidity may be present without further protection.

•

Installation should only be performed by a qualified professional

•

Install in accordance with all appropriate wiring standards

•

DALI is not SELV and needs to be wired accordingly

•

Never connect a LED fitting to a driver that is powered. Doing so may result in damage to the LED.

•

Always make sure the output voltage range and output current of the LED driver match the requirements of the

•

LED fitting. Failure to do so may result in damage both the driver and fitting.

The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.

•

Do not install under mechanical stress.

•

Allow for expansion due to changes in temperature.

•

Please be aware that while the system has a very long operational life, faults may still occur, and provision needs to be made for maintenance.

•

Always turn off power before working on fitting.

•

Specifications

Dimensions

Length

Weight

Cut out Size

Minimum installed depth (with mounting springs)

Mounting spring width (installed)

Clearance Information

digilin.com.au

+617 3899 1267

25.1 x 11.9

Custom

260

112

RISK OF OVERHEATING OR FIRE IF THE CLEARANCE DISTANCES ARE COMPROMISED.

Minimum distance from the top of the luminaire to any

normally flammable building element or insulation

Minimum distance from the side of the luminaire to any

normally flammable building element

Minimum distance from the side of the luminaire to any

building insulation

Minimum distance from side of luminaire to drive gear

U n i t s

0mm

40mm

Product specifications are subject to change without notice

Document Rev: 1.1 - 22 August 2022

Page 1 of 2