Cres Cor CO151HW189B 설치, 운영 및 유지보수 매뉴얼 - 페이지 5

{카테고리_이름} Cres Cor CO151HW189B에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor CO151HW189B 13 페이지. Cres cor aquatemp humidity convection and retherm ovens

5925 Heisley Road • Mentor, OH 44060-1833
HOW TO START UNIT
(After fi rst-time operation):
Push POWER switch "ON".
Preheat:
In HOLD mode, preheat unit to 180°F/82°C for 60
minutes.
STANDARD OPERATION
1.
Set Cook/Retherm thermostat to the cooking
temperature you need.
2.
Set Hold thermostat to the warming temperature
you need after the cook cycle. Proper food holding
temperature is 140°F/60°C or higher.
3.
Set Timer for the cooking time. Press timer start
button. The oven will automatically switch to the pre-
set hold temperature after cooking time has expired.
COOK (HUMIDITY) OPERATION
HOW TO COOK:
1.
Set Cook/Retherm thermostat to the cooking
temperature you need.
2.
Set Hold thermostat to the warming temperature you
need after the cook cycle.
HOLD
Dial Setting
Temp.,°F/°C
1
140/60
15
150/66
10
160/71
5
180/82
5
200/93
5
Values Listed are % Relative Humidity.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
OPERATING INSTRUCTIONS (continued)
TEMPERATURE / HUMIDITY SETTINGS
2
3
20
25
15
20
10
15
5
10
5
5
NOTE: Cold food is NOT to be added to
the unit when operating in the HOLD mode.
HOW TO COOK, continued
3.
Set Humidity control to the desired relative humidity
you need in the oven. This setting is for both COOK
and HOLD cycles.
4.
Set Timer for the cooking time. Press timer start
button. The oven will automatically switch to the pre-
set hold temperature after cooking time has expired.
HOW TO PROOF:
1.
Fill the water pan with three (3) gallons of HOT
water.
2.
Set the Humidity control at low to mid-range.
3.
Set the Hold control to Proof.
4.
Preheat the oven at this setting for ½ hour.
5.
Put in product. DO NOT use frozen product.
6.
Listed below are typical thermostat settings.
Experiment with different settings to get the
temperature and humidity that you need.
TO SHUT DOWN UNIT:
Push POWER switch to "OFF".
NOTE: Ventilating fans will continue to run until cabinet
is cool. Do NOT disconnect the power supply to the
cabinet while the ventilating fan is still operating.
HUMIDITY
Dial Setting
4
5
6
35
50
65
25
35
55
20
30
40
15
20
25
10
15
20
FL-2270
Ovens
Rev. 10 (4/08)
Page 5 of 13
7
8
9
85
100
100
70
100
100
60
80
100
30
50
70
25
35
50
10
100
100
100
95
75