Cres Cor 1000HHSS2DX 운영 및 유지보수 지침 매뉴얼 - 페이지 3
{카테고리_이름} Cres Cor 1000HHSS2DX에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor 1000HHSS2DX 6 페이지. Insulated hot cabinets
페이지 인쇄
5925 Heisley Road • Mentor, OH 44060-1833
for Models: 1000HHSS2DX and 1200HHSS2DX Hot Cabinets
UPPER
POWER
SWITCH
DISPLAY BUTTON
HOW TO CHANGE FROM °F TO °C (if needed)
1. Push the switch on; the light will come on.
2. Push and hold the "SET" button and the button in
the lower left hand corner together for 5 seconds.
You are now entered into the menu.
3. Scroll over the "Unit" and change it to "C" , then
scroll to the "END".
FIRST TIME START-UP:
NOTE: A new oven needs to "burn off"
manufacturing oils and excess adhesive
before its first use. Do NOT load food into
oven until this has been done!
1. Push the POWER switch; the light will come on.
NOTE: The letters "LOTPR" (Low Temperature)
will show on the control panel until it reaches
140°F (60°C).
2. Turn the control knob to show 200°F (93°C).
Push the knob to set the temperature. Run the unit
for one (1) hour.
3. Push the switch off and let cool.
4. Wipe the inside clean with detergent and hot
water.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
OPERATING INSTRUCTIONS
DIGITAL CONTROL
"UPPER COMPARTMENT"
°F
ADJUST
SET
LOWER
POWER
"LOWER COMPARTMENT"
SWITCH
HOW TO HOLD FOOD:
1. Push the POWER switch; the light will come on.
NOTE: The letters "LOTPR" (Low Temperature)
ADJUST
SET
will show on the control panel until it reaches
140°F (60°C).
2. Turn the digital control knob(s) to a temperature
for upper and/or lower compartments, between
140°F (60°C) and 220°F (104°C). Push the knob
to set the temperature.
3. Preheat the cabinet for one (1) hour.
4. Put product into cabinet.
NOTE: Press the "Display" button to see the actual
temperature inside the cabinet.
TO TURN OFF UNIT:
Push the POWER switch off; the light will go out.
WARNING
Air is VERY HOT when door is opened.
Insulated
FL-2390
Hot Cabinet
Rev. 0 (2/16)
Page 3 of 6
DIGITAL CONTROL
°F