Cres Cor 1000-CH-SS 설치 및 운영 매뉴얼 - 페이지 5
{카테고리_이름} Cres Cor 1000-CH-SS에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor 1000-CH-SS 14 페이지. 1000-ch series radiant ovens
페이지 인쇄5925 Heisley Road • Mentor, OH 44060-1833
Power
Switch
FOR FIRST-TIME OPERATION ONLY:
A new oven needs to "burn off" factory oils and glue before
it's fi rst use. Do NOT load food into oven until this has
been done!
1.
Push switch to "ON".
2.
Set the
Cook thermostat to 325°F/163°C.
3.
Set the
Hold thermostat to 150°F/66°C.
4.
Set the timer to one (1) hour.
5.
Allow oven to run automatically for one (1) hour of
Cook cycle and 30 minutes of Hold cycle.
6.
Turn oven off and let cool.
7.
Wipe inside clean with detergent and hot water.
WARNING
Air is VERY HOT when door is opened.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
OPERATING INSTRUCTIONS
Timer
Thermometer
Thermostat
"Hold"
Yellow
Light
HOW TO START UNIT
(after fi rst-time operation):
Push POWER switch "ON".
NOTE: For HOLD or COOK mode, preheat unit to desired
temperature for 30 minutes.
For Automatic Operation:
1.
Set
Cook thermostat to the cooking temperature you
need.
2.
Set
Hold thermostat to the warming temperature you
need. Proper food holding temperature is 140°F/60°C or
higher.
3.
Set
Timer for the roasting time. The unit will
automatically switch to the pre-set "hold" temperature
after roasting time has expired.
For Holding Operation ONLY:
Cold food is NOT to be added when unit is
operating in HOLD mode.
1.
Set
HOLD thermostat to the temperature you need.
2.
Set Timer at zero.
TO SHUT DOWN UNIT:
Push SWITCH to "OFF".
NOTE: Ventilating fans will continue to run until cabinet is
cool. Do NOT disconnect the power supply to the
cabinet while the ventilating fan is still operating.
FL-2340
Ovens
Rev. 5 (7/08)
Page 5 of 14
Thermostat
"Cook"
Green
Light