Digilock ADA User Key 빠른 운영 및 프로그래밍 - 페이지 3
{카테고리_이름} Digilock ADA User Key에 대한 빠른 운영 및 프로그래밍을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock ADA User Key 3 페이지. Blue; shared usage locks standard & high security
페이지 인쇄
To operate with a user code:
To lock:
1) Find an available lock.
2) press:
c ` ` ` ` K
(any four-digit code)
To unlock:
1) At same lock.
2) press:
c ` ` ` ` K
(same code used to lock)
To operate with an ADA user key:
To lock:
1) Find an available lock.
2) touch the ADA user key (blue) to key slot.
To unlock:
1) At same lock.
2) Touch the ADA user key (blue) to key slot.
To operate with the manager bypass keys:
To lock or unlock:
1) touch a registered manager bypass key (black) to key
slot .
To operate with the programming key:
To lock or unlock:
1) Press:
c K
2) Insert programming key (red) to key slot.
www.spaequip.net
For lost or stolen keys:
For a lost programming key:
Contact your Digilock Product Representative to order a re-
placement programming key.
For a lost manager bypass key(s):
1) collect all remaining manager keys or order additional keys
from your Digilock Product Representative .
2) At one lock press c K 5 5 K
The LED will flash.
3) Touch the programming key (red) to the key slot for one full
second.
The LED is solid.
4) Touch the programming key (red) to the key slot for one full
second.
The LED will turn off and all registered manager keys will
be erased on the one lock.
5) Follow instructions "To add additional manager bypass
keys." If you have more than one lock, continue with steps 6
and 7.
6) Follow instructions " To initialize new locks: (step 2)."
7) Follow instructions "To initialize new locks: (step 3)."
Troubleshooting
1) No Audible feedback when c button is pressed:
A) the batteries have failed- replace batteries located in
the rear unit.
B) poor connection on door- remove lock from door and
reinstall.
C) The lock is in "sleep state." Try again after one minute.
2) Lock does not unlock:
A) listen for additional audible feedback for an indicator as to
what is going on.
B) Try operating with manager bypass key or programming key
C) Contact your Digilock Product Representative or Digilock
customer support.
3) Lock emits 2 sets of three beeps during operation:
A) low battery indicator- replace batteries located in the rear
unit.
4) lock emits 10 rapid beeps during operation:
A) binding indicator- the lock is binding with the strike plate.
Press firmly on the door while operating. If binding is a fre-
quent occurrence, the strike plate and/or door hinges need to
p: 707.737.1100
be aligned with the lock.
Additional Product Features
Product Code: DL01KUSR104
If you have the high security platform, this product line is capable
of audit trail with use of a software programming kit. For addi-
tional information regarding this feature contact your Digilock
product representative.
For Additional Product and/or
Product Information:
Visit: www.digilock.com
E-mail: [email protected]
Contact: Digilock or your Digilock Product Representative
5341 Old Redwood Highway, Suite 200,
Petaluma, CA 94954
Phone: (800) 989.0201
Fax: (800) 986.4221
(
707) 766.6000
(707) 766.6226
Page 3 of 3