FIAMA F1X502SSI 사용 및 유지 관리 매뉴얼 - 페이지 7

{카테고리_이름} FIAMA F1X502SSI에 대한 사용 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIAMA F1X502SSI 8 페이지. Display unit with microprocessor

Display unit with microprocessor

Number of bits of the SSI interface

Number of bits of the SSI protocol to be set in line with the value requested by the transducer connected to

the F1X5_SSI display unit. Such value can range between 4 and 24.

Default value: 24. Value for the MAT transducer: 24.

SSI data item with or without sign

It defines the display mode of the data provided by the SSI transducer. Example: with

communication in binary format, dimension 1111 is displayed as 15 , otherwise, if

being negative numbers represented in two's complement.

N.B: if the bit number is 24, all the negative dimensions are displayed with negative sign regardless of the

value of

Value for the MAT transducer: 0

Displayed dimension offset

By means of this constant it is possible to add or subtract a value from the dimension shown on the display.

By setting a positive value, this value is subtracted from the displayed dimension. By setting a negative

value, this value is added to the displayed dimension.

Position of the decimal point

This constant indicates the position of the decimal point; set 0 for no decimal, 1 for 1 decimal, etc... Allowed

values: 0 to 4.

Dimension multiplication factor

The display unit can modify the value read by the transducer by multiplying it by

. By setting these two constants properly, the chosen value can be shown on the display. The range of

allowed values is 1 ÷ 999999. Default value 1.

Dimension division factor

See above.

Overall dimensions

Date:13/01/16

F1X_SSI_ing.doc

F1X5_SSI

= 0, in a 4-bit

= 1, –1 is displayed,

and dividing it by

Pag. 7/7