Digilock ATV 프로그래밍 및 작동 지침 - 페이지 2
{카테고리_이름} Digilock ATV에 대한 프로그래밍 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock ATV 4 페이지. Keypad locks advanced security
페이지 인쇄
Programming Instructions
Initial Setup
New locks operate only with = `
a.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns on.
b.
Touch each Manager Bypass Key to the key slot. A two-tone beep will be heard for each Manager Bypass Key that is
successfully registered.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
d.
Repeat above steps for each lock or follow Express Register instructions to setup all locks.
Express Register
Manager Bypass Key(s) can be quickly registered to multiple locks. The Programming Key copies the registered Manager Bypass
Key(s) from one lock to multiple locks.
a.
Go to the lock registered with the Manager Bypass Key(s).
b.
Press = ` 66 `. The LED will start to flash.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
d.
At each lock to be registered, touch the Programming Key to the key slot until a two-tone beep is heard and the LED
flashes once to indicate successful registration.
Register/Add Manager Bypass Key(s)
Up to 25 Manager Bypass Keys may be registered to a lock. If required, contact your Digilock Product Representative to order
additional Manager Bypass Key(s).
a.
Go to a lock requiring Manager Bypass Key(s).
b.
Press = ` 55 `. The LED will start to flash.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns on.
d.
Touch each Manager Bypass Key to the key slot. A two-tone beep will be heard for each Manager Bypass Key that is
successfully registered.
e.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
f.
Repeat above steps for each lock or follow Express Register instructions to register the same Manager Bypass Key(s) to
multiple locks.
For Lost or Stolen Keys
For a lost or stolen Programming Key:
To prevent the lost/stolen Programming Key from operating the locks, immediately order a Replacement Programming Key
from your Digilock Product Representative. Once received, follow enclosed instructions to set up the lock(s) to operate with the
Replacement Programming Key.
For a lost or stolen Manager Bypass Key(s):
To prevent the lost/stolen Manager Bypass Key(s) from operating the lock(s), erase all registered Manager Bypass Key(s) and register
only the remaining Manager Bypass Key(s).
a.
Collect all remaining Manager Bypass Key(s).
b.
Press = ` 55 `. The LED will start to flash.
c.
Touch the Programming Key to the key slot until a two tone beep is heard and the LED turns on.
d.
Touch the Programming Key to the key slot again until three sets of two-tone beeps are heard and the LED turns off.
All previously registered Manager Bypass Key(s) have been erased from the lock.
e.
Follow Register/Add Manager Bypass Key(s) instructions to register the remaining Manager Bypass Key(s).
Product Guide
Keypad Locks Advanced Security
.
Locks must be setup to allow full operation.
Shared Use
ATS, ATV & ATH
Phone: 707 766 6000
www.digilock.com | [email protected]