Digilock Curve 제품 설명서 - 페이지 11

{카테고리_이름} Digilock Curve에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock Curve 11 페이지. Keypad | basic & advanced
Digilock Curve에 대해서도 마찬가지입니다: 제품 설명서 (8 페이지)

페이지 인쇄

SUPPORT

Sleep Mode

After three consecutive incorrect User Code entries to unlock, the lock will go into "Sleep Mode" for one minute and for an additional

minute for each subsequent incorrect entry. The keypad is disabled while in "Sleep Mode." A valid Manager Key may be used to unlock

while the lock is in "Sleep Mode."

Error Condition Indicators

10 rapid beeps:

The lock is binding which means that either door alignment or stored items are preventing the lock from operating. Press on the door

while operating the lock. If error condition persists, contact Digilock support for assistance.

2 sets of three beeps:

The batteries are low. Replace the batteries.

Does Not Unlock with the User Code or User Key

The lock does not recognize the User Code or User Key. For immediate access, operate with a valid Manager Key. If in assigned use

functionality, follow instructions to Assign the User Credentials to assign user credential to the lock.

Does Not Operate with a Manager Key

The lock does not recognize the Manager Key. Follow instructions to Add Manager Keys to program the Manager Key to the lock. For

immediate access, operate with another valid Manager Key or with the Programming Key.

Does Not Operate with the Programming Key

The lock does not recognize the Programming Key. If the Programming Key has been replaced, operate with the Replacement

Programming Key. Contact Digilock support for additional assistance.

No Audible Feedback when

• The lock may be in "Sleep Mode" or the batteries may need to be replaced. For immediate access, operate with a valid Manager Key.

• The front unit may not be properly connected to the rear unit. Remove the lock from the door and check the connection.

LOCK BATTERY REPLACEMENT

It is not necessary to remove the lock from the door. In case of battery failure, operate with a valid Manager Key.

Remove the Cover Plate screw with a

Phillips head screwdriver.

Remove the Cover Plate by lifting the tab

at the edge of the cover, below the arrows.

CAUTION:

Risk of explosion or leakage if battery is replaced by an incorrect type, mixed with a different battery type, or inserted

backwards. Replace all batteries of a set at the same time. Be sure to insert batteries with correct polarities. Remove exhausted batteries

from product promptly and dispose of used batteries according to the battery manufacturer's instructions.

CONTACT INFORMATION

For inquiries regarding new products, please contact our sales department: 707 766 6000 | [email protected]

For replacement products, returns, or technical support, please contact our support department: 707 766 6000 | [email protected]

PG-D6CKX-D-DEN

P R O DU CT GU I D E

Keypad | Basic & Advanced

is Pressed

Remove the batteries from the housing.

Replace with four premium alkaline AA

batteries. Dispose of or recycle used

batteries according to local regulations.

Replace the Cover Plate and secure with

the Cover Plate screw.

081722