Digilock Curve 제품 설명서 - 페이지 3
{카테고리_이름} Digilock Curve에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock Curve 8 페이지. Keypad | basic & advanced
Digilock Curve에 대해서도 마찬가지입니다: 제품 설명서 (11 페이지)
페이지 인쇄
PROGRAMMING INSTRUCTIONS - ADDING KEYS
Add Manager Credentials
Manager credentials can be programmed to the locks at any time.
1
Insert and hold Programming
Key in place for 5 seconds.
The LED will flash, and a two-
tone beep will be heard after 5
seconds.
PROGRAMMING INSTRUCTIONS - REPLACING KEYS & CREDENTIALS
The locks must be reprogrammed to prevent the lost/stolen Programming Key or manager credentials from operating a lock.
Replace the Programming Key
1
Note the order or serial number (found on the lock's rear unit).
Replace the Manager Credentials
1
Collect all remaining and
replacement manager
credentials.
Go to any lock operated by the
lost/stolen manager credentials.
3
P R O DU CT GU I D E
Touch-Free RFID | Basic & Advanced
2
sec
Once the two-tone beeps
are heard, remove key, then
reinsert key.
LED will continue to flash.
2
Insert programming key and
hold for 5 seconds,
the LED will turn on and a two-
tone beep will be heard.
3
Insert each additional Manager
Key or present each Manager
RFID credential one at a time.
A two-tone beep will be heard
for each manager credential
programmed.
2
Contact Digilock Support to purchase a replacement
Programming Key.
3
sec
Remove programming key and
insert again, LED will flash.
Remove key and insert again.
Three sets of two-tone beeps
will be heard and the LED will
turn off.
4
or
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat preceding steps for
each lock or follow instructions
to Express Register Manager
Credentials to quickly program
the same manager credentials
to operate multiple locks.
4
x3
All previously programmed
manager credentials will be erased.
Follow instructions to
Add Manager Credentials
to program the remaining
and replacement manager
credentials to the locks.