Digilock DAK1-APS1 제품 설명서 - 페이지 4

{카테고리_이름} Digilock DAK1-APS1에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock DAK1-APS1 4 페이지. Keypad locks advanced security assigned use 4g

페이지 인쇄

Support

Sleep Mode

After three consecutive incorrect User Code entries to unlock, the lock will go into "Sleep Mode" for one minute and for an additional

minute for each subsequent incorrect entry. The keypad is disabled while in "Sleep Mode".

Error Condition Indicator

Locks emit feedback when an error condition exists.

10 rapid beeps:

The lock is binding which means that either door alignment or items in the locker are preventing the lock from operating. Press on the

door while operating the lock. If error condition persists, contact Digilock Support for assistance.

2 sets of three beeps:

The batteries are low. Replace the batteries.

1 beep:

The lock does not recognize the User Code or Key.

Does not Unlock with the User Code or User Key

The lock does not recognize the User Code or User Key. Follow Assign User Credential instructions to assign a new User Code or

User Key to the lock. For immediate access, operate the lock with a registered Manager Bypass Key.

Does not Operate with a Manager Bypass Key

The lock does not recognize the Manager Bypass Key. Follow Register/Add Manager Bypass Key(s) instructions to register

the Manager Bypass Key to the lock. For immediate access, operate with another registered Manager Bypass Key or with the

Programming Key.

Does not Operate with the Programming Key

The lock does not recognize the Programming Key. Contact Digilock Support for assistance.

No Audible Feedback when

The lock may be in "Sleep Mode" or the batteries need to be replaced. For immediate access, operate with a registered Manager

Bypass Key. Press = to test; if no audible feedback, replace the batteries.

If error condition persists, loosen the mounting hardware and test.

If error condition persists, remove the lock and assemble in your hand to test. If the door is locked or damage is visible, contact

Digilock Support.

If the lock functions when assembled in your hands, reinstall and test again.

If error condition persists, contact Digilock Support.

Battery Replacement

The batteries are located in

the rear unit of the lock.

PG-DAK1-AP-DEN

021314

Product Guide

Keypad Locks Advanced Security

Assigned Use

is Pressed

Remove the screws and the

cover plate.

DAK1-APS1, DAK1-APV1 & DAK1-APH1

Pull the battery pack from the

rear housing.

Replace with four premium

alkaline AA batteries.

Place the battery pack back

into the rear housing and

screw cover plate in place.

Phone: 707 766 6000