Digilock DCR1-ATV1 제품 설명서 - 페이지 4

{카테고리_이름} Digilock DCR1-ATV1에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock DCR1-ATV1 4 페이지. Rfid cam locks advanced security, shared use

Support

Error Condition Indicator

Locks emit feedback when an error condition exists.

2 sets of three beeps:

The batteries are low. Replace the batteries.

1 beep:

The lock does not recognize the RFID Access Credential.

Does not Unlock with the RFID Card, User Key, or RFID Access Credential

The lock does not recognize the RFID Card, User Key, or RFID Access Credential. Operate the lock with a registered Manager Key.

Does not Operate with a Manager Key

The lock does not recognize the Manager Key. Follow Register/Add Manager Key(s) instructions to register Manager Key to the lock.

For immediate access, operate with another registered Manager Key or with the Programming Key.

Does not Operate with the Programming Key

The lock does not recognize the Programming Key. Contact Digilock Support for assistance.

No Audible Feedback when

The batteries may need to be replaced.

Replace the batteries.

If error condition persists, contact Digilock Support.

Battery Failure

If the door is locked and the batteries have failed, use the Manager Key to provide external power and operate the lock.

Touch and hold the Manager Key to the key slot for approximately 10 seconds until a triple-tone beep is heard.

Turn the knob/lever to the unlocked position.

Battery Replacement

It is not necessary to remove the lock from the door to change the batteries.

The batteries are located

behind the rear cover.

Ensure that the cam is not

obstructing access to the rear

cover screw.

PG-DCR1-AT-DEN

081715

Product Guide

RFID Cam Locks Advanced Security

is Pressed

Remove the screw and rear

cover.

Shared Use

DCR1-ATV1

Replace with three premium

alkaline AA batteries.

Replace the rear cover and

secure the screw in place.

Phone: 707 766 6000