Cres Cor CO151027 설치, 운영 및 유지보수 매뉴얼 - 페이지 8
{카테고리_이름} Cres Cor CO151027에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor CO151027 12 페이지. 2kw rethermalizer
페이지 인쇄FL-CO151027
Rethermalizer
Page 8 of 12
Rev. 1 (1/16)
HOW TO CLEAN THE UNIT:
SOIL
ROUTINE CLEANING
CABINET
STUBBORN SPOTS,
STAINS
Inside and Outside
BURNT ON FOODS OR
GREASE
(Stainless Steel)
HARD WATER SPOTS &
SCALE
HOW TO ADJUST THE DOOR LATCH:
1 . For vertical (up and down movement) adjustment:
a . Loosen (2) screws located in magnetic strike .
b . Move strike up or down for alignment to
magnet on latch .
c . Tighten screws to secure
WARNING
IF UNIT GETS TOO HOT OR WON'T SHUT OFF, DISCONNECT
POWER AT BRANCH PANEL. DO NOT UNPLUG CORD!
1 . Cord is unplugged from wall outlet .
2 . Circuit breaker/fuse to wall outlet is blown .
PROBLEM
Unit does not turn on
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
MAINTENANCE INSTRUCTIONS
TROUBLE-SHOOTING GUIDE, continued
* Mild detergents include soaps and non-abrasive cleaners
TROUBLE-SHOOTING GUIDE
If unit is NOT working, first check the following causes:
POSSIBLE CAUSE
1. Power switch is bad
2. Thermostat control is bad.
5925 Heisley Road • Mentor, OH 44060-1833
CLEANER
Soap, ammonia or mild
detergent* and water.
Mild abrasive made for
Stainless Steel.
Chemical cleaner made
for Stainless Steel.
Vinegar
2 . For horizontal (greater or lesser magnetic draw)
adjustment:
a . Loosen (4) screws in door latch .
b . Move latch forward or backward to adjust
magnetism .
c . Tighten screws to secure .
3 . Switch is turned off .
4 . Fuse on back of unit is blown .
METHOD
1. Sponge on with cloth
2. Rinse
1. Apply with damp sponge or cloth.
2. Rub lightly.
Follow cleaner manufacturer's
directions.
1. Swab or wipe with cloth.
2. Rinse and dry.
SOLUTION
1. Replace
2. Replace