Digilock NEXT cue 제품 설명서 - 페이지 2

{카테고리_이름} Digilock NEXT cue에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock NEXT cue 6 페이지. Rfid interface bolt mechanism
Digilock NEXT cue에 대해서도 마찬가지입니다: 제품 설명서 (5 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

Setup

Locks are shipped with factory default settings (only operates by pressing `). Setup must be completed to program the Programming Key

and Manager Keys or Manager RFID Credentials to all the locks.

Insert the Programming Key.

A two-tone beep will be heard

and the LED will turn on.

Programming Instructions

Express Register Manager Credentials

The Programming Key can quickly program the same Manager Keys and Manager RFID Credentials to operate multiple locks.

Go to the lock already programmed to operate with the Manager Keys and

Manager RFID Credentials.

Press and hold

for 10 seconds (a two-tone beep will be heard after 5

seconds followed by 2 sets of two-tone beeps after 10 seconds) then release.

The LED will turn on.

At each lock to be programmed, insert the Programming Key.

A two-tone beep will be heard and the LED will ﬂ ash once to indicate

successful programming.

* The Programming Key will continue to function in Express Registration mode until it is used to operate a lock.

Product Guide

While the LED is on, insert one

Manager Key or present one

Manager RFID Credential at a time.

A two-tone beep will be heard for

each Manager Key or Manager RFID

Credential programmed.

RFID Interface

Latch Mechanism

Assigned Use Functionality

Insert the Programming Key.

A two-tone beep will be heard

and the LED will turn off.

While the LED is on, insert the Programming Key.

A two-tone beep will be heard and the LED will turn off.

To end Express Registration mode:

Go to any programmed lock.

Press

then insert the Programming Key*.

Note: The latch will automatically release and re-lock 6 seconds

after unlocking.

Repeat above steps for each lock

or follow instructions to Express

set up all locks.