Cres Cor CO151X185B 설치, 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} Cres Cor CO151X185B에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor CO151X185B 10 페이지. Convection and retherm ovens
Cres Cor CO151X185B에 대해서도 마찬가지입니다: 설치, 운영 및 유지보수 매뉴얼 (9 페이지), 설치, 운영 및 유지보수 매뉴얼 (12 페이지)

Cres Cor CO151X185B 설치, 운영 및 유지보수 매뉴얼
5925 Heisley Road • Mentor, OH 44060-1833
877/CRES COR (273-7267) • 440/350-1100
Fax: 440/350-7267 • www.crescor.com
WARNING!
BEFORE cleaning the cabinet:
1. Unplug cord from wall. Allow
cabinet to cool.
2. Do NOT hose cabinet with water.
3. Do NOT get water on controls.
4. Do NOT use abrasives or harsh
chemicals.
Wipe up spills as soon as possible.
Clean regularly to avoid heavy dirt build-
up.
CABINET
Inside and
Outside
(Stainless Steel)
*MILD DETERGENTS INCLUDE SOAPS AND NON-ABRASIVE CLEANERS.
WARNING!
IF UNIT GETS TOO HOT OR WON'T SHUT OFF, DISCONNECT
POWER AT BRANCH PANEL. DO NOT UNPLUG CORD!
If hot unit is NOT working, first check the following causes:
1. Cord is unplugged from wall outlet.
2. Circuit breaker/fuse to wall outlet is
blown.

MAINTENANCE INSTRUCTIONS

HOW TO CLEAN THE UNIT:

SOIL
CLEANER
Soap, ammonia or mild
Routine Cleaning
detergent* and water.
Stubborn Spots,
Mild abrasive made for
Stains
Stainless Steel.
Burnt on Foods or
Chemical oven cleaner
Grease
made for Stainless Steel.
Hard Water Spots
Vinegar
& Scale
MAINTENANCE INSTRUCTIONS
TROUBLE-SHOOTING GUIDE
Undercounter Ovens
Rev. 1 (9/04)
Cleaning Hints:
1. Use the mildest cleaning procedure that
will do the job.
2. Always rub in the direction of polish
lines to avoid scratching the surface.
3. Use only a soft cloth, sponge, fibrous
brushes, plastic or stainless steel pads for
cleaning and scouring.
4. Rinse thoroughly with fresh water after
every cleaning operation.
5. Always wipe dry to avoid water marks.
METHOD
1. Sponge on with cloth
2. Rinse
1. Apply with damp
sponge or cloth.
2. Rub lightly.
Follow oven cleaner
manufacturer's directions.
1. Swab or wipe with
cloth.
2. Rinse and dry.
3. Switch is turned off.
4. Thermostat is turned off, or is set too
low.
FL-2292
6 of 10
Page