FIAMA P1X 매뉴얼 - 페이지 2
{카테고리_이름} FIAMA P1X에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIAMA P1X 11 페이지.
페이지 인쇄Inputs description
The positioner is controlled by 4 optoinsulated inputs that are:
START:
active from open to close; it starts the positioning;
EMERGENCY: it must usually be closed; if it is open, it stops the positioning;
WORK COUNTER:
from closed to open of the work counter input in order to carry on the subsequent positioning;
RESET:
active from closed to open; it determines the resetting/presetting of the dimension or the zero
research.
For the relevant connections see wiring diagram on page 10
Outputs description
The positioner can manage the following outputs:
STOP/ONWARD/BACKWARD: it controls the speed and the motion direction of the positioned axis,
SLOW/FAST:
END OF POSITIONING:
AUXILIARY OUTPUT(AUX):
For the relevant connections see wiring diagram on page 10
Description of the front panel
The display1 always displays the axis dimension, whereas the other displays show different parameters as a
function of the positioner status.
The function indicators show the currently selected function.
DISPLAY 1
DISPLAY 2
DISPLAY 3
DISPLAY 4
INDICATORI
FUNZIONE
PROGRAMMING
The keys used for programming are the following:
P
Function choice programming
E
Enter to confirm the entered values
C
Clear to cancel/enter values
Increment or start key(only in the automatic/semiautomatic function)
START -
STOP +
Decrement or stop key (only in the automatic/semiautomatic function)
The programming and the use of the positioner is based on 8 main functions the selection of which is obtained
by pressing the P key followed by the relevant numerical key. The default function present when the tool is
switched on is the automatic/semiautomatic function (A/S); when the P key is pressed, the
display the
writing (function choice) followed by the numerical key corresponding to the wished
data: 13/01/16
work counter input; at the end of every positioning the instrument waits for a switchover
it controls the slow/fast speed of the positioned axis;
contact that closes at the end of positioning;
programmable auxiliary contact (end of cycle, work number, etc).
5
PROG
COST
MAN
ZERO
1
START
STOP
-
file: P1X_ing.doc
7
<<
4
<
6
8
7
1
TEST
CYCL
SING
A/S
3
2
4
P
E
C
+
8
9
>>
5
6
>
2
3
.
0
DISPLAY
pag 2 di 11
will
2