FIAMA P2X0T 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} FIAMA P2X0T에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIAMA P2X0T 11 페이지. Positioner with analog output

페이지 인쇄

Input description

The positioner is controlled by 4 opto-isolated inputs, that are:

START:

active from NA to NC, it causes the positioning start and brings different effects according to

the working mode (see working mode at page 4).

EMERGENCY: it must be normally closed, if open it blocks or interrupts the positioning

PIECECOUNTER: at the end of each positioning the instrument expects a changing over of the piece counter

input from NC to NA to proceed to the next positioning. NB: if not used connect it in parallel

with the

PRESET:

the changing over from NA to NC causes the reset or the preset loading according to the

zero reset procedure constant (see zero reset procedure page 6).

For switches see the connections scheme at page 10.

Output descriptions

The positioner is able to manage 3 relays outputs:

START/STOP:

FORWARD/BACKWARD:

END POSITIONING:

ANALOG OUTPUT

For switches see the connections scheme at page 10

PROGRAMMING

The following keys are used to programme:

PGM

to start and to leave the programming mode of the instrument

to change from one constant to another or to increase the digit value during modification

or to change from one digit to the next one

to confirm inserted values

RESET/ENTER

To enter programming mode is necessary to press the PGM key ; on the display you will see the

write

(immediate positioning); by the key

(cycles),

to insert an immediate positioning dimension (see next paragraph)

to insert dimensions and positioning programs, number of pieces and cycles (see next

paragraph)

per impostare il numero di cicli del programma di posizionamento da eseguire (vedi

"Impostazione del numero di cicli" a pagina 4)

to enter the machinery constants of the positioner (see Setting up of Machinery Constants

at page 4)

to change to manual operating mode of positioner (see Manual Operating mode at page 7)

to test inputs and outputs (see Test function at page 7)

data: 13/01/16

input.

START

normally open switch that closes to allow positioning

change-over switch that controls the direction of motion of the positioned axis

normally open switch that closes at positioning end

voltage selectable 0÷10V or –10÷10V, and current 4-20mA

(costanti),

(manual),

File: P2XT_smd_ing.doc

you can run through the menus

(test) whose functions are the following:

(quote),

pag 2 di 10