Digilock Curve RFID Basic 설치 매뉴얼 - 페이지 5
{카테고리_이름} Digilock Curve RFID Basic에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock Curve RFID Basic 13 페이지. Deadlatch/deadbolt motorized rear
페이지 인쇄WOOD DOOR DRILLING INSTRUCTIONS
Door Mounting Holes Drill Instruction and Template
1
(b)
With the door open place the Template over the locker frame.
(a) Align the edge of Strike Plate with the Strike Plate Marker.
(b) Center the Template to the center of the Strike Plate.
You may secure the Template with removable tape.
3
(a)
Place the Template on the front of the door.
(a) Align the drawn mark on the Template with the door edge.
(b) Center the Template with the mark on the door.
Secure the Template with removable tape.
HOLE MOUNTING TEMPLATE
Before printing, turn off auto scaling or "Fit to Paper" in your printer setup and print at 100%
CENTER LINE
5
I NSTALL GU ID E
Keypad & RFID | Basic & Advanced
(a)
(b)
ALIGN EDGE OF
STRIKE PLATE HERE
FOR
LEFT
CLOSING DOOR
ALIGN EDGE OF
STRIKE PLATE HERE
FOR
LEFT
CLOSING DOOR
2
(b)
Close the door over the Template.
(a) Mark the door edge at the Template Center Line.
(b) Mark the Template with the edge of the door.
4
5/16" 0.3125in
Mark the center points of the door mounting holes on the
front of the door. Drill the holes according to the specified
dimensions.
0.31"
[7.94mm]
1.09"
0.75"
[27.75mm]
[19mm]
2.19"
[55.5mm]
1.09"
[27.75mm]
0.31"
[7.94mm]
0.92"
0.92"
[23.4mm]
[23.4mm]
(a)
Drill x2
[7.94 mm]
ALIGN EDGE OF
STRIKE PLATE HERE
FOR
RIGHT
CLOSING DOOR
CENTER LINE
ALIGN EDGE OF
STRIKE PLATE HERE
FOR
RIGHT
CLOSING DOOR
Drill 3/4"
0.75in [19mm]