Digilock Curve 제품 설명서 - 페이지 5
{카테고리_이름} Digilock Curve에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock Curve 11 페이지. Keypad | basic & advanced
Digilock Curve에 대해서도 마찬가지입니다: 제품 설명서 (8 페이지)
페이지 인쇄
PROGRAMMING INSTRUCTIONS - IN ASSIGNED USE FUNCTIONALITY
Express Register User Credentials and Manager Keys
Make sure the lock is set for assigned use functionality (a green LED will flash when
program multiple locks to operate with the same user credentials and Manager Keys.
1
Go to a lock already
programmed to operate
with the user credentials and
Manager Keys.
Press
= ` 66 `
LED will turn on.
*The Programming Key will continue to function in express registration mode until it is used to operate a lock.
Remove User Credentials
Make sure the lock is in assigned use functionality (a green LED will flash when
remove user credentials from operating a lock.
1
Collect all remaining and replacement user credentials
(User Codes and User Keys).
3
Insert a valid Manager Key.
A two-tone beep will be heard.
5
P R O DU CT GU I D E
Keypad | Basic & Advanced
2
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
. The
4
Insert the Manager Key again.
Three sets of two-tone beeps will be heard
and the LED will turn off.
All previously assigned user credentials
will be removed.
is pressed). The Programming Key can quickly
=
3
Insert the Programming Key to
program each lock to operate
with the same user credentials
and Manager Keys.
Two sets of two-tone beeps will
be heard and the LED will flash
twice to indicate successful
programming.
is pressed). The locks must be reprogrammed to
=
2
Press
.
= ` 55 `
The LED will turn on.
5
Follow Assign User Credentials
instructions to assign the remaining and
replacement user credentials.
4
End express registration mode.*
Go to any programmed lock,
press
, then insert the
= `
Programming Key.
Press
, then insert the
= `
Programming Key again to
return the bolt to the original
position.