Digimax 210 사용자 설명서 - 페이지 5

{카테고리_이름} Digimax 210에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digimax 210 12 페이지. Programmable thermostat compatible with maxi controller
Digimax 210에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)

페이지 인쇄

2 Locate and identify the two option Links 1 and 2. Use a pair

of small wire cutters to cut the appropriate links to give the

required configuration.

3 Cutting Link 1 will give a minimum temperature set point

of 16°C (factory default is 5°C). Cut link 2 to display cooling

symbol instead of heating symbol.

4 Replace batteries being sure to observe the correct

polarities. Re-fit to plastic base and tighten retaining screw.

Check unit is functioning as required.

VII Battery replacement

A "flashing" battery low symbol will appear at the bottom left

of the display when the batteries start to approach the end of

their life. This indicates that they should be replaced within

the next month. Ultimately, the display will start flashing and

the thermostat will shut down until the batteries are replaced.

To replace the batteries, the following procedure should be

carried out. The thermostat should be isolated from the mains

before proceeding.

1 Slacken the retaining screw on the unit and open by hing-

ing upwards the top edge.

2 Remove batteries and fit two new "AA" alkaline cells taking

care to observe the correct battery polarities. Check unit is

functioning

3 Re-fit it to the plastic base and check that the RF link still

operates. This can be easily done by adjusting the

requested temperature under or over the level of the

ambient temperature, in order to activate and disactivate

several times the boiler while watching the green LED on

the RF-Max receiver.