Crescendo audio Concerto Series 소유자 매뉴얼 - 페이지 3
{카테고리_이름} Crescendo audio Concerto Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crescendo audio Concerto Series 8 페이지.
페이지 인쇄c3000.2D & c2000.4D CONTROLS & CONNECTIONS
RCA INPUT
RCA OUTPUT
RCA OUTPUT :
Output RCA jack to another amplifier.
GAIN ( 6V ~ 0.2V )
Matching the output voltage of
the headunit's
RCA line-outs to amplifier's input.
HPF ( 20(200)~800(8K)HZ @ 12dB )
Control the high pass filter
frequency forthe speaker outputs.
When setting multiply x1, then
the frequencies can be
adjusted from 20Hz to 800Hz.
When setting multiply x10, then
the frequencies can be
adjusted from 200Hz to 8KHz.
Select HPF ON/OFF switch
RCA INPUT :
Connect preamp signal
cables from the source or
the headunit to RCA input.
LPF ( 50(500)~800(8K)HZ @ 12dB )
Control the low pass filter
frequency forthe speaker outputs.
When setting multiply x1, then
the frequencies can be
adjusted from 50Hz to 800Hz.
When setting multiply x10, then
the frequencies can be
adjusted from 500Hz to 8KHz.
Select HPF ON/OFF switch
MODE
Select mode switch for input conenction
2CH or 4CH.
POWER & PROTECT LED
POWER LED ; Blue-lit shows correct operation.
PROTECT LED : Red-lit shows general
malfunction, faulty connection, or
thermal protection.
CLIP LED
When c2000.4D power is clsoe to
the clipping level, CLIP LED starts to clip.
As clipping level comes, clip LED is
clipping and then, finally come to
the protection in RED light on.