Crescent SC800 문제 해결 매뉴얼 - 페이지 2
{카테고리_이름} Crescent SC800에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crescent SC800 2 페이지.
Crescent SC800에 대해서도 마찬가지입니다: 사용자 및 유지보수 매뉴얼 (2 페이지)
페이지 인쇄ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
The machine
doesn't work
as it should?
The suction
doesn't work
as it should?
The machine
doesn't clean
as it should?
The brushes
don't work as
they should?
1 Check if the power cable is correctly
connected.
1 Check if the suction hose is
correctly installed and cleaned.
1 Check if you have the right
detergent and water settings.
1 Check if the brushes are correctly
installed and not worn out.
2 Check if the battery is charged.
2 Open the recovery tank and check
if the vacuum grid and gasket are
cleaned.
2 Check if the solution/clean water
tap is open.
2 Check if there isn't any brush motor
overload i.e. 3 battery Ledsflash
simultaneously or error code on dis -
play.
3 Turn the ignition key to "0", then
try to start the machine without
pressing the paddle.
3 Check if squeegee blades are dam -
aged or dirty.
3 Check if the solution filter is
cleaned.
3 Check if there are external materials
avoiding brush.
www.crescentindustrial.co.uk
SC800
4 Check if the surfaces has a gradient
exceeding the specifications.
4 Close the recovery tank cover prop -
erly and/or verify the gasket wear.
4 Check if the isn't any dirty in the
EcoFlex™ system.
4 Check if the Leds are on. Wait until
the lights are steady.