Accusplit Eagle 1120M2 운영 지침

{카테고리_이름} Accusplit Eagle 1120M2에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Accusplit Eagle 1120M2 1 페이지. Accusplit memory pedometer instruction manual
Accusplit Eagle 1120M2에 대해서도 마찬가지입니다: 운영 지침 (1 페이지)

페이지 인쇄

Congratulations on taking the ﬁrst step to wellness with your purchase of an ACCUSPLIT

pedometer. It's easy to set up your new pedometer. Just follow the steps below, and start walking!

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer

onto your belt or the top edge of your pants or skirt. It should

ﬁt snugly and level, above one knee.

Note: The pedometer should be as vertical as possible.

Walkers with larger stomachs may ﬁnd it helpful to wear the

pedometer farther back on the body, toward one hip.

To avoid losing or dropping your pedometer, use the included

leash and clip to fasten the pedometer securely to your

clothing.

Attaching the Leash: Attach the pedometer to the leash by

looping the leash around the pedometer belt clip. Next, clasp

the waistband of your clothing with the attached clip. You can

also use a safety pin to fasten the leash to your clothing, loop

the leash through your belt or belt loop, or use a badge holder.

First, loop the

pedometer clip

Next, loop the metal

clip, then clasp clothing

Or, loop a belt

or belt loop

VIEWING YOUR RESULTS

Once you put on your pedometer, it will automatically begin

to record your steps. Press the DAY button to view today's

step count. Press the TOTAL button to view total steps taken.

ACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA

800-935-1996 • 925-290-1900 • FAX 925-290-1930 • www.ACCUSPLIT.com • [email protected]

ACCUSPLIT®

EAGLE

MEMORY PEDOMETER

OPERATING INSTRUCTIONS

Or, loop a

badge holder, then

put into pocket

(Badge holder

not included)

1120M2

™

MODES

• "D"– "Day's Steps"

Counts steps taken since last RESET.

• "T"–"Total Steps"

Keeps track of all steps taken, even after

Day's Steps are reset.

TOTAL button

AccuSTEP

ACCUSPLIT

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily.

To reset: While displaying Day's Steps, press and hold DAY

button for at least three seconds to reset to zero. When

displaying Total Steps, press TOTAL button for three seconds

to reset Total and Day's Steps to zero.

AUTO MOVEMENT SENSOR

1. To ﬁlter out random movements, the unit remains in standby

mode until 5 continuous steps are registered. Only then are

the 5 steps calculated in, and an Active indicator "▲" appears

on the upper left of display.

2. When regular walk/run movement stops, after 2 seconds the

timer pauses and the unit switches to standby status (Active

indicator "▲" disappears).

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to replace

the battery. Your pedometer uses one Type L1142 (LR43) 1.5

volt silver oxide battery. To replace:

1. Using a jeweler's screwdriver, loosen small screw on back of

unit. Remove back of case.

2. Slide the old battery gently out of its holder. Replace it with a

new battery. The battery's positive (+) terminal should be

FACE UP while you put it into the pedometer.

3. Gently press front and back of pedometer case back together,

being sure to line up slots and tabs at top and bottom of unit.

Please return

your AE1120M2 Registration to

the Repair Center address in the

warranty, and we will let you

know about future products.

DAY button

10000.org

EAGLE

1 1 2 0 M 2

T W 1 5 M G

Email (preferred)

User

970-043