Diginet LEDsmart MMDM/PB 설치 매뉴얼 - 페이지 6

{카테고리_이름} Diginet LEDsmart MMDM/PB에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diginet LEDsmart MMDM/PB 16 페이지. Push button dimmer with built in on / off switch and multi-way control

페이지 인쇄

Wiring for two-way dimming and switching

To achieve two-way dimming and switching using LEDsmart

dimmers have an integrated switch, therefore no separate switches or additional strappers are required for two-way on/off

control.

New Installation – two-way dimming and switching

Two-way dimming and switching using LEDsmart

dimmers are simply wired in parallel.

Replacing existing two-way switching with two-way dimming/switching

When replacing existing two-way switching with two-way dimming/switching using LEDsmart

wires can be re-used. No new wiring is required. See the wiring diagrams below.

Existing two-way switching

Traditional two-way switching using standard rocker switch

mechanisms and strappers between the switches.

dimmers, the two dimmers are connected in parallel. Note that the

dimmers. Note the two-wire

Replacement two-way dimming/switching

Rocker switches replaced with LEDsmart+ dimmers using

the existing strapper wires. No new wiring required.

Push Button Dimmer/Switch

, the existing two-way 'strapper'