ABB ScreenMaster RVG200 매뉴얼 - 페이지 2
{카테고리_이름} ABB ScreenMaster RVG200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ScreenMaster RVG200 17 페이지. Paperless recorder terminal block failures
ABB ScreenMaster RVG200에 대해서도 마찬가지입니다: 시운전 지침 (17 페이지), 배터리 교체 절차 (4 페이지), 매뉴얼 (2 페이지), 서비스 지침 (2 페이지)
페이지 인쇄
2
S C R E E N M A S T E R R V G 2 0 0 / PA P E R L E S S R E C O R D E R | C I/ R V G 2 0 0/0 0 1 - E N R E V. A
Health & Safety
Safety precautions
Be sure to read, understand and follow the instructions
contained within this manual before and during use of the
equipment. Failure to do so could result in bodily harm or
damage to the equipment.
WARNING
Installation and maintenance of this product must
only be conducted by personnel authorized to work
on electrical installations and in accordance with
relevant local regulations..
Potential safety hazards
Electrical
WARNING
To ensure safe use when operating this equipment,
the following points must be observed:
• Up to 240 V AC may be present. Be sure to isolate
the supply before removing the terminal cover.
• Normal safety precautions must be taken to avoid
the possibility of an accident occurring when
operating in conditions of high pressure and / or
temperature.
Safety advice concerning the use of the equipment
described in this manual or any relevant Material
Safety Data Sheets (where applicable) can be
obtained from the Company, together with servicing
and spares information.
Safety standards
This product has been designed to satisfy the requirements of
IEC61010-1:2010 3rd edition 'Safety Requirements for Electrical
Equipment for Measurement, Control and Laboratory Use' and
complies with US NEC 500, NIST and OSHA.
Safety conventions
WARNING
In this manual, a warning is used to indicate a
condition which, if not met, could cause serious
personal injury and / or death. Do not proceed
beyond a warning until all conditions have been met.
CAUTION
A caution is used to indicate a condition which, if not
met, could cause minor or moderate personal injury
and / or damage to the equipment. Do not proceed
beyond a caution until all conditions have been met.
IMPORTANT (NOTE)
A note is used to indicate important information or
instructions that should be considered before
operating the equipment.
EC Directive 89/336/EEC
Electrical – In order to meet the requirements of the EC
Directive 89/336/EEC for EMC regulations, this product must
be used in an industrial environment.
End-of-life disposal (Europe only)
The recorder contains a small lithium battery that
must be removed and disposed of responsibly in
accordance with local environmental regulations.
The remainder of the recorder does not contain any
substance that causes undue harm to the
environment and must be disposed of in accordance
with the Directive on Waste Electrical and Electronic
Equipment (WEEE). It must not be disposed of in
Municipal Waste Collection.
Cleaning
The complete recorder can be hosed down if it has been
installed to IP66 / NEMA 4X standards – see Section
page 4. Warm water and a mild detergent can be used.
2
,