Cisco 1503 소프트웨어 설명서 - 페이지 21

{카테고리_이름} Cisco 1503에 대한 소프트웨어 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1503 49 페이지. Cisco systems switch user manual

Firmware Load and Restart Commands

Use the commands in this section to configure how the hub loads and copies firmware.

Bootup Option Commands

Use the commands in this section to configure how the hub gets the firmware and IP address

when it is first powered up.

bootup-option

Syntax:

Mode:

Description:

no bootup-option

Syntax:

Mode:

Description:

bootup-option {normal | tftp-download | bootp-get-ip | bootp-download}

Administrator

Configures how the hub will obtain an IP address when it is first turned on.

This setting is stored in the hub Flash read-only memory.

Command Keyword Definitions

• normal—Default setting for the Micro Hub 1502. The hub uses the IP

address stored in the onboard firmware.

• tftp-download—Downloads firmware from a TFTP server. The download

process is repeated every time the hub is rebooted.

• bootp-get-ip—Default setting for the Micro Hub 1503. The hub obtains the

IP address from the local BOOTP server.

• bootp-download—The hub obtains the IP address and firmware from a

local BOOTP server. The firmware is then saved in Flash memory.

no bootup-option

Administrator

Resets the hub to the default bootup option, which is to use the onboard ROM

code and the default IP address (normal).

Firmware Load and Restart Commands

Using Your Hub Software 3-21