Cisco 1538 series 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} Cisco 1538 series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1538 series 8 페이지. Micro hub 10/100 cabling and start up
Cisco 1538 series에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지)
페이지 인쇄
Connect the Hub to Other Network Devices
Note: Use a straight-through cable to
connect two ports when one of the ports is
designated with an X. Use a crossover cable
2
to connect two ports when both ports are
designated with an X.
You can change the designation of port 5 by
using the MDI/MDI-X button. When the
button is IN, the port is not crossed. When
the button is OUT (default), the port is
crossed.
Connect the Hub to Servers,
Routers, and Workstations
•
Connect a Category 3, 4, or 5
straight-through cable to any 10/100
port on the hub and to a 10BaseT port
on the workstation, server, or router.
•
Connect a Category 5 straight-through
cable to any 10/100 port on the hub and
to a 100BaseTX port on the
workstation, server, or router.
C is co 15
38 M
UP
1x
2x
10/1 00
3x
RAT ING
4x
100 -127
SPE ED
/200 -240
LED
0.3A /
V~
DOW N
100B aseT
0.2 50/6
X
0 Hz
10Ba seTX
ON
OFF
1
2 3 4
5 6 7
8
MDI
MDI -X
5x
6x
7x
8x
CON SOLE
10/100 network
port (RJ-45)
Ethernet cable
(not supplied)
Maximum cable length:
328 ft (100 m)
Connect the Hub to Switches
and Other Hubs
•
Connect a Category 3, 4, or 5 crossover
cable to any 10/100 port on the hub and
to a 10BaseT port on the target switch
or hub.
•
Connect a Category 5 crossover cable to
any 10/100 port on the hub and to a
100BaseTX port on the target switch or
hub.
10BaseT or
100BaseTX port
(RJ-45)