Cisco 200E Series 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Cisco 200E Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 200E Series 13 페이지. Advanced smart switches

To rack-mount the switch in any standard rack, attach the rack–mount

brackets to the sides of the switch with the supplied hardware and secure

the brackets tightly.

For stability, load the rack from the bottom to the top, with the

AUTION

heaviest devices on the bottom. A top-heavy rack is likely to

be unstable and may tip over.

Connecting Network Devices

To connect the advanced smart switch to the network:

Connect the Ethernet cable to the Ethernet port of a computer,

TEP

printer, network storage, or other network device.

Connect the other end of the network Ethernet cable to one of the

TEP

numbered advanced smart switch Ethernet ports.

The LED of the port lights if the device connected is active. Refer to

Features of the Cisco Small Business Smart Switch, page 8

details about the different ports and LEDs on each switch.

Repeat

TEP

the advanced smart switch.

Cisco strongly recommends using Cat5 or better cable for Gigabit

OTE

connectivity. When you connect your network devices, do not exceed

the maximum cabling distance of 100 meters (328 feet). It can take up to

one minute for attached devices or the LAN to be operational after it is

connected. This is normal behavior.

If your switch is one of the PoE models, consider the following:

As a PSE (Power Sourcing Equipment) device, the switch can deliver a

maximum of 15.4 Watts per PoE port to a PD (Powered Device).

The switch should be connected only to PoE networks without

ARNING

routing to the outside plant

200E Series Advanced Smart Switches

Step 1

and

Step 2

for each device you want to connect to

for