Cisco 2651XM-V 운영 - 페이지 9

{카테고리_이름} Cisco 2651XM-V에 대한 운영을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2651XM-V 25 페이지. Modular access routers with aim-vpn/ep fips 140-2 non-proprietary security policy

페이지 인쇄

Figure 5

POWER

RPS

Any NM or WIC slot, which is not populated with a NM or WIC, must be populated with an appropriate

slot cover in order to operate in a FIPS compliant mode. The slot covers are included with each router,

and additional covers may be ordered from Cisco. The same procedure mentioned below to apply tamper

evidence labels for NMs and WICs must also be followed to apply tamper evidence labels for the slot

covers.

Once the router has been configured in to meet FIPS 140-2 Level 2 requirements, the router cannot be

accessed without signs of tampering. To seal the system, apply serialized tamper-evidence labels as

follows:

Clean the cover of any grease, dirt, or oil before applying the tamper evidence labels. Alcohol-based

Step 1

cleaning pads are recommended for this purpose. The temperature of the router should be above 10 C.

Place the first label on the router as shown in

Step 2

that the one half of the tamper evidence label covers the enclosure and the other half covers the side of

the router. Any attempt to remove the enclosure will leave tamper evidence.

Place the second label on the router as shown in

Step 3

so that the one half of the tamper evidence label covers the enclosure and the other half covers the side

of the router. Any attempt to remove the enclosure will leave tamper evidence.

Step 4

Place the third label on the router as shown in

that the one half of the label covers the enclosure and the other half covers the Network Module slot.

Any attempt to remove a Network Module will leave tamper evidence.

Place the fourth label on the router as shown in

Step 5

that the half of the label covers the enclosure and the other half covers the WAN interface card slot.

Any attempt to remove a WAN interface card will leave tamper evidence.

Place the fifth label on the router as shown in

Step 6

that one half of the label covers the enclosure and the other half covers the WAN interface card slot.

Any attempt to remove a WAN interface card will leave tamper evidence.

Step 7

The labels completely cure within five minutes.

Cisco 2621XM and Cisco 2651XM Modular Access Routers with AIM-VPN/EP FIPS 140-2 Non-Proprietary Security Policy

OL-6262-01

Cisco 2621XM and Cisco 2651XM Chassis Removal

ACTIVITY

Cisco 2600

SERIES

Figure

6. The tamper evidence label should be placed so

Figure

6. The tamper evidence label should be placed

Figure

6. The tamper evidence label should be placed so

Figure

6. The tamper evidence label should be placed so

Figure

6. The tamper evidence label should be placed so

The 2621XM/2651XM Router