digiO2 ECG-10X 사용자 설명서 - 페이지 10

{카테고리_이름} digiO2 ECG-10X에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. digiO2 ECG-10X 13 페이지. Ecg/ekg recorder

．Do not take measurements when there are drops of water on your skin,

such as from sweat or after bathing.

．Do not take measurements where the unit will be exposed to strong

electromagnetic forces.

．ln order to achieve accurate measurements, please replace new batteries

when low battery indicator is on.

．Safety hazard may occur in case the final system does not provide

sufficient insulation to mains and earth, however, the equipment can be

safely connected to other IEC/EN 60601-1 approved equipment that has

all its connectors intended for connection to this unit separated from

earth by basic insulation.

．Do not use this product in combination with non IEC/EN 60601-1

approved computers/adaptors.

．Any ECG/EKG record erased from the unit cannot be recovered.

．Do not wash this unit with water.

．Do not store the unit in the following ambient conditions:

(1) Locations exposed to direct sunlight.

(2) Locations subject to high temperatures and high humidity.

(3) Wet or damp locations where water may get on the unit.

(4) Dusty locations.

(5) Near fires or open flames.

(6) Locations exposed to strong vibration.

(7) Locations exposed to strong electromagnetic fields.

．Parts of electrodes and other connectors should not contact other

conductive parts including earth.

．The medical system that will connect to this unit or another equipment

shall comply with IEC/EN 60601-1-1.

．When ECG transfer data through USB cable to PC, the ECG is no power no

function, to avoid any elctronic shock, please do not use ECG to measure

when USB cable is connecting PC.

Maintenance and Storage

．Clean the unit with a cloth dampened with water or mild detergent, then

wipe it dry with a dry cloth.

．Wipe the electrodes using a cloth dampened with ethyl alcohol (75%

v/v).

．Do not wipe the unit with benzene, gasoline, paint thinner, concentrated

alcohol, or other volatile detergents.

．Do not place objects on top of the unit. It could damage the unit.

．Do not disassemble the unit. Repairs should only be carried out by digiO2

authorized personnel.

．There is no sensor in the ECG/EKG; therefore, this unit does not require

calibration.

．Remove the batteries from this unit when you are not going to use it for a

long period of time (approximately three months or more).