Accusplit Eagle AE1590 사용 설명서

{카테고리_이름} Accusplit Eagle AE1590에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Accusplit Eagle AE1590 2 페이지. Accusplit pedometer instuction manual

페이지 인쇄

ACCUSPLIT®

OPERATING INSTRUCTIONS

Congratulations on taking the first step to wellness with your

purchase of an ACCUSPLIT pedometer. It's easy to set up your

new pedometer. Just follow the steps below, and start walking!

SETTING UP YOUR PEDOMETER

To record your distance and calories

accurately, you will need to set your stride

length and body weight.

Finding Your Stride Length: Your stride

length is the length of one of your steps,

measured from "toe to toe." To measure,

walk 10 steps with your normal stride and

measure the TOTAL DISTANCE from the

toe of your starting step to the toe of your

step (see diagram below). Divide the

TOTAL DISTANCE by 10. This is your stride

length. Example: If you walk 22 feet, your

stride length is 2.2 feet.

Setting Your Stride Length: Press the

black MODE button until arrow at the top

of display points to "DIST." Press the gray

SET button once to enter setting mode.

Display will shift to show stride (for example,

"F 1.95" means stride is set to 1.95 feet).

Press the gray SET button to increase stride

length. Press the yellow RESET button to

decrease stride length. Press the black

MODE button to exit setting mode.

Setting Your Weight: Press the black MODE

button until arrow at the top of the display

points to "CAL." Press the gray SET button

once to enter setting mode. Display will shift

to show weight in pounds. For example, "L

165" means weight is set to 165 lbs. Press

the gray SET button to increase weight

setting. Press the yellow RESET button to

decrease weight setting. Press black MODE

button to exit weight setting mode.

Setting the Clock: Press the black MODE

button until the arrow on the top of display

points to clock icon

. Press the gray SET

button once to enter clock setting mode,

clock readout will flash. Press the yellow

RESET button to advance hours. Press the

gray SET button to advance minutes. Press

black MODE button to exit clock setting

mode.

Note: display will show "A" for AM and

"P" for PM.

10 steps

ACCUSPLIT, Inc. • 6120 Stoneridge Mall Rd., Suite 210 • Pleasanton, CA 94588 USA

800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • [email protected]

EAGLE

PEDOMETER

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide

the pedometer onto your belt or the top edge

of your pants or skirt. It should fit snugly and

level, above one knee.

Note: The pedometer should be as vertical as

possible. Walkers with larger stomachs may

find it helpful to wear the pedometer farther

back on the body, toward one hip. The cover

must be closed for the pedometer to work.

To avoid losing or dropping your pedometer,

use the included leash and clip to fasten the

pedometer securely to your clothing.

Attaching the Leash: Attach the pedometer

to the leash by looping the leash around the

pedometer belt clip. Next, clasp the waistband

of your clothing with the attached clip. You can

also use a safety pin to fasten the leash to

your clothing, or loop the leash through your

belt or belt loop.

Next, loop the metal

clip, then clasp clothing

Or, loop a belt or belt loop

VIEWING YOUR RESULTS

Once you put on your pedometer with the

cover closed, it will automatically begin to

record your steps, distance, calories burned,

and activity time. Repeatedly press the

black MODE button to cycle through the

pedometer modes:

STEPS → DISTANCE → CALORIES →

TIME OF DAY → ACTIVITY TIMER →

SCAN → STEPS

1590

™

First, loop the

pedometer clip

badge holder, then

put into pocket

(Badge holder

not included)

DISPLAY MODES

• STEP: STEP mode shows your

step count since last reset, up

to 1,000,000 steps.

• DIST: DISTANCE mode shows

distance walked or jogged since

last reset.

• CAL: CALORIE mode shows

calories burned through step

activity since last reset.

•

: CLOCK mode shows time of day.

•

: ACTIVITY TIMER MODE

shows total activity time in minutes

and seconds since last reset. The

timer runs automatically whenever

steps are being recorded.

• SCAN MODE: Rotates between

showing steps, distance, calories

and activity time.

ACCUSPLIT EAGLE

RESET

(2S)

Yellow:

RESET

AUTO MOVEMENT SENSOR

1. To filter out random movements, the

unit remains in standby mode until

5 continuous steps are registered.

Only then are the 5 steps calculated

in, and an Active indicator "▲"

Or, loop a

appears on the upper left of display.

2. When regular walk/run movement

stops, after 2 seconds the timer

pauses and the unit switches to

standby status (Active indicator "▲"

disappears).

RESETTING YOUR PEDOMETER

Most people prefer to reset step, distance,

and calorie counts daily. To reset: From

STEP, DISTANCE, or CALORIE mode,

press and hold the yellow RESET button

for at least 2 seconds.

Current mode

arrow indicator

CAL

DIST STEP

ACTIVITY

PEDOMETER

TW15G

1590

SET

MODE

Black:

Gray:

MODE

SET

970-046