Cisco 2960 8TC - Catalyst Switch 시작하기 매뉴얼 - 페이지 9

{카테고리_이름} Cisco 2960 8TC - Catalyst Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2960 8TC - Catalyst Switch 23 페이지. 8-port switches

The Cisco Configuration Engine is a network management device that works with embedded CNS

agents in the switch software. You can use Cisco Configuration Engine to automate initial

configurations and configuration updates on the switch.

See the "Accessing Help Online" section on page 18 for a list of supporting documentation.

Installing the Switch

This section describes installation information specific to the Catalyst 2960-8TC, Catalyst

2960G-8TC, and Catalyst 2960PD-8TT-L switches. For information applicable to the other

Catalyst 2960 switches, see the Catalyst 2960 Switch Hardware Installation Guide on Cisco.com,

which includes installation instructions for all Catalyst 2960 switch models.

This section covers desk-, shelf-, and magnet-mounting. As an example, all the illustrations show the

Catalyst 2960-8TC switch. For alternate mounting procedures, such as installing the switch in a rack

or on a wall, see the Catalyst 2960 Switch Hardware Installation Guide on Cisco.com.

You need this equipment to install the switch:

•

Number-2 Phillips screwdriver

•

Drill with a #27 drill bit (0.144-inch [3.7 mm])