Bye Bye Standby BBSLP 매뉴얼 - 페이지 2

{카테고리_이름} Bye Bye Standby BBSLP에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bye Bye Standby BBSLP 2 페이지.

To Use

Before you can use your socket, you must set it up. See overleaf for details.

4. To use, plug the device that you would like to control into your Bye Bye Standby socket and press the green button to

activate standby mode and the red button to take your appliance oﬀ standby.

5. If you press the ALL ON button on your remote control all your sockets will be turned on, if you press the All Oﬀ Button all

of your sockets will be turned oﬀ.

Resetting The Socket

1. Ensure your Bye Bye Standby socket is turned oﬀ, hold down the oﬀ button on your remote control for three seconds.

2. Hold down the ALL OFF button on the remote control until the LED on the socket ﬂashes rapidly and then once every

second.

Tips

To control your Bye Bye Standby socket with an additional remote control:

1. Each socket can be controlled by more than one remote control, including remote controls from the Bye Bye Stadnby classic

range.

2. To use your new Bye Bye Standby socket with a Bye Bye Standby classic remote control simply follow the set-up instructions

overleaf using A1 on your Bye Bye Standby classic remote control or any other code you wish to set.

Troubleshooting

If your socket doesn't respond to the remote control:

1. The battery in your remote control may have lost charge, consider changing the battery.

2. The socket and remote are too far apart, move closer to the socket.