Cisco 2960G-8TC - Catalyst Switch 시작하기 매뉴얼 - 페이지 2

{카테고리_이름} Cisco 2960G-8TC - Catalyst Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2960G-8TC - Catalyst Switch 23 페이지. 8-port switches

About This Guide

This document describes information specific to the Catalyst 2960-8TC, Catalyst 2960G-8TC, and

Catalyst 2960PD-8TT-L switches. For information applicable to the other Catalyst 2960 switches, see

the Catalyst 2960 Switch Hardware Installation Guide on Cisco.com.

This guide provides instructions on how to use Express Setup to configure your Catalyst switch. Also

covered are switch management options, basic installation procedures, port and module connections,

power connection procedures, and troubleshooting help.

For additional installation and configuration information for Catalyst 2960 switches, see the Catalyst

2960 documentation on Cisco.com. For system requirements, important notes, limitations, open and

resolved bugs, and last-minute documentation updates, see the release notes, also on Cisco.com.

When you use the online publications, refer to the documents that match the Cisco IOS software

version running on the switch. You can use the show version command to display software version

information.

For translations of the warnings that appear in this publication, see the Regulatory Compliance and

Safety Information for the Catalyst 2960 Switch that accompanies this guide.

Follow these steps:

1. Unpack and remove the switch and the accessory kit from the shipping box.

2. Return the packing material to the shipping container, and save it for future use.

3. Verify that you have received the items shown in the "Shipping Box Contents" section. If any item

is missing or damaged, contact your Cisco representative or reseller for instructions. Some switch

models might include additional items that are not shown. Your switch might be a different model

from the one that is shown in this illustration

Equipment That You Supply to Run Express Setup

You need to supply this equipment to run Express Setup:

• PC

• Ethernet (Category 5) straight-through cable (as shown)