BYECOLD IGT1-HH0606-1 사용 설명서 - 페이지 7
{카테고리_이름} BYECOLD IGT1-HH0606-1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BYECOLD IGT1-HH0606-1 9 페이지. Infrared ceiling heater
페이지 인쇄WARNING
To avoid falling off, slide the panel left and right to make sure the two hooks
have been completely put into the rear of the two long frames!
PUSH
7┃OPERATION INSTRUCTIONS(additional instructions)
The device can operate in 3 different modes.
Mode A
Insert the mains plug into a properly fused mains socket or
hardwire the device with a fused switch, control it with a switch.
Mode B
Control the device with a built-in remote thermostat
Mode C
Control the device with a built-in WIFI and remote thermostat
Please check more details in the additional page.
8┃TROUBLESHOOTING
Problem
It has noise when original
Due to the structure
charged with electricity
stress of the heat
insulator.
The surface of the device
Due to the thermal
was slightly raised.
expansion of the surface
material.
The surface of the heating
1. The voltage is low.
device is slightly warm.
2. In a low-temperature
environment.
PUSH
Reason
Measure
It is a normal phenomenon.
Don't worry about it.
It is a normal phenomenon.
Don't worry about it.
1. Install a voltage regulator.
2. It is normal.
9┃MAINTENANCE & SERVICING
Activities required before starting maintenance
Warning of electrical voltage
•
Do not touch the mains plug with wet or damp hands.
•
Hold onto the mains plug while pulling the power cable out of the mains
socket.
•
Allow the device to cool down completely.
Warning of electrical voltage
•
Tasks which require the housing to be opened must only be carried out by
authorized specialist companies.
Cleaning the device
Warning of electrical voltage
•
Never immerse the device in water!
•
Clean the device with a soft, damp and lint-free cloth.
•
Ensure that no moisture enters the housing. Protect electrical
components from moisture. Do not use any aggressive cleaning agents
such as cleaning sprays, solvents, alcohol-based or abrasive cleaners to
dampen the cloth.
•
Wipe the housing dry after cleaning
10┃STORAGE
When the device is not being used, observe the following storage conditions:
• dry and protected from frost and heat
• in an upright position where it is protected from dust and direct sunlight
• with a cover to protect it from invasive dust, if necessary.
• Place no further devices or objects on top of the device to prevent it from
being damaged.