Cisco 2980G - Catalyst Switch 자주 묻는 질문 매뉴얼
{카테고리_이름} Cisco 2980G - Catalyst Switch에 대한 자주 묻는 질문 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2980G - Catalyst Switch 7 페이지. Quality of service (qos) feature
Cisco 2980G - Catalyst Switch에 대해서도 마찬가지입니다: 하드웨어 문제 해결 (30 페이지)
페이지 인쇄
Quality of Service on Catalyst 4500/4000 Switches
Running CatOS FAQ
Document ID: 17953
Questions
Introduction
Which QoS features do Catalyst 4500/4000 switches that run CatOS support?
What is the minimum software that is necessary for QoS on Catalyst 4500/4000 switches
that run CatOS?
Do the Catalyst 4500/4000 switches that run CatOS support rate−limiting or policing on
ports or VLANs?
Can the Catalyst 4500/4000 switches that run CatOS mark or rewrite IP precedence
Type of Service (ToS) bits in an IP packet?
What kind of input scheduling do the Catalyst 4500/4000 switches that run CatOS
provide?
Can the Catalyst 4500/4000 switches that run CatOS change the incoming Class of
Service (CoS) value in IEEE 802.1Q (dot1q) tags?
My server cannot tag Class of Service (CoS) values. Can the Catalyst 4500/4000 switches
that run CatOS tag the traffic from the server for a specific CoS value?
Do the Catalyst 4500/4000 switches that run CatOS honor the incoming Class of Service
(CoS) value in IEEE 802.1Q (dot1q) tags from my IP phones?
Can the Catalyst 4500/4000 switches that run CatOS extend the trust or override the
incoming Class of Service (CoS) value of devices connected to the IP phones?
What kind of output scheduling do the Catalyst 4500/4000 switches that run CatOS
provide?
I enabled QoS on a Catalyst 4500/4000 switch that runs CatOS and now I see
performance issues. What is wrong?
How do the QoS features on the Catalyst 4500/4000 switches that run CatOS compare to
Catalyst 4500/4000 switches that run Cisco IOS Software? How do the features compare
with the features of the Layer 3 (L3) switching module?
NetPro Discussion Forums − Featured Conversations
Related Information
Introduction
This document addresses frequently asked questions (FAQ) on the Quality of Service (QoS) feature of the
Cisco Catalyst 4500/4000 (Supervisor Engine I and Supervisor Engine II) series, Catalyst 2948G, Catalyst
2980G, and Catalyst 4912G switches that run Catalyst OS (CatOS). This document refers to these switches as
"Catalyst 4000 switches that run CatOS". For QoS features on Catalyst 4500/4000 switches that run Cisco
IOS® Software, refer to the document Configuring QoS.
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Q. Which QoS features do Catalyst 4500/4000 switches that run CatOS
support?
A. Catalyst 4500/4000 switches that run CatOS support input classification and output